V-Tec DT596/KP User Manual page 16

1 2 3
4 5 6
7 8 9
0 #
*
Input the master code.
(Default: [ ] +[#] )
1.Reset all settings
Input the setting code.
00+#
(red) (blue)
ON
ON
Beep+, Beep
Inputting of code
1234+#
(red) (blue)
ON OFF
Beep+
- When the "
* cancel" key is pressed, the LED lights off, the buzzer beeps, and the system exits the setting mode
- When there isn't any operation in 10s, the LED lights off, the buzzer beeps, and the system exits the setting mode
- All settings will restore to their
default value.
- When power on or activate
the reset all setting item,the
keypad checking will carry out,
during this time,the key
illumination will blink and the
touching operation is forbidden,
after finish checking,the key
illumination will stop blinking
and sent out a long sound of beep
red
blue Each•operation•is•indicated•by•the•lighting•up•of•the•LED•
indicators• on• the• right• section• of• the• unit,• and• by• the•
sounding•of•the•buzzer.
2.Setting the master code
(Default 1234)
Input the setting code.
01+#
(red) (blue)
ON
ON
Beep+, Beep
Inputting of new master code
(ex.: 4321)(1~12 digits)
4321+#
(red) (blue)
ON OFF
Beep+
- The master code is allowed 1~12
digits,the same code cannot be set
for both the user code and the
master code,it is recommended
that you modify the default master
code.
-14-
(red)
ON
3.Setting the key
illumination time
(Default 10s)
Input the setting code.
02+#
(red) (blue)
ON
ON
Beep+, Beep
Inputting of code (ex.: 10)
range:00 or 10~99
10+#
(red) (blue)
ON OFF
Beep+
- If the key illumination time is set
to 00,the key illumination will light
up all the time when power on.
- If the key illumination time is set to
10~99,the key illumination will light
up for 10~99 seconds.At this mode,
the key illumination lights off in
standby mode, touching any digital
key can illuminate,but this is the
invalid digital.
(blue)
OFF
Beep+, Beep
4.Setting the
unlock time
(Default 1s)
Input the setting code.
03+#
(red) (blue)
ON
ON
Beep+, Beep
Inputting of code (ex.: 09)
range:01~99
09+#
(red) (blue)
ON OFF
Beep+
(red) (blue)
OFF OFF
Beep, Beep+
- The unlock time can be set on
both monitor and door station,
and the valid value is the number
you set last time.