V-Tec DT-DJ4A User Manual
  1. Manuals
  2. Brands
  3. V-Tec Manuals
  4. Intercom System
  5. DT-DJ4A
  6. User manual

V-Tec DT-DJ4A User Manual

2-wire system indoor monitor, audio phone
Hide thumbs

Advertisement

Table of Contents

DT-DJ4A
Audio Phone

User Manual

2
Read this manual carefully before using the product, and keep it well for future use.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DT-DJ4A and is the answer not in the manual?

Questions and answers

Related Manuals for V-Tec DT-DJ4A

Summary of Contents for V-Tec DT-DJ4A

  • Page 1: User Manual

    DT-DJ4A Audio Phone User Manual Read this manual carefully before using the product, and keep it well for future use. ...

  • Page 3: Parts And Functions

    1. Parts and Functions Handset Unlock button Call button/Unlock 2nd button Speaker handset curve Side View Key functions Handset Pick up to communicate with visitor. Handset curve Connect handset with monitor. Unlock button Press to release the door. In standby mode, pick up handset, then press Call button to Call button/Unlock activate the inner call;...

  • Page 4: Terminal Descriptions

    2. Terminal Descriptions SW+,SW- L1, L2 DIP2 DIP1 SW+,SW-:Door bell call button connection port. L1,L2:Bus terminal. K4:Used to Ring Tone setting. K3:Used to Ring Volume setting. DIP1(Bit1~6):Used to User Code setting. DIP2(Bit1~3):Used to Slave Monitor Address or Extended Address setting. 3.

  • Page 5: Setup Instructions

    4. Operation Instructions 1) Door release function: When visitor calls from outdoor station, the monitor rings, pick up handset to talk with the visitor, then press the Unlock button to open the door. If the system connect 2 locks,press Unlock 2nd button to open the second door. 2) Inner call: Pick up handset, then press CALL button to activate the inner call,all monitors connected to the system will ring at the same time.
  • Page 6 Bit state User Code Bit state User Code Bit state User Code Code=6 Code=17 Code=28 3 4 5 3 4 5 3 4 5 Code=7 Code=18 Code=29 3 4 5 3 4 5 3 4 5 Code=8 Code=19 Code=30 3 4 5 3 4 5 3 4 5 Code=9...

  • Page 7: Ring Tone Setting

    5.2.2 When Bit-3 of DIP2 set to ON, the Bit-1~2 of DIP2 and Bit-1~5 of DIP1 are used to extended address setting: DIP2 state DIP1 state User Code DIP2 state DIP1 state User Code Code=1 Code=65 3 4 5 3 4 5 Code=2 Code=66 3 4 5...

  • Page 8: Specification

    2). Pick up handset in standby mode, each time you press K4 to replace a group of ring tones. Four groups ring tones cycle: press K4 press K4 press K4 Group1 Group2 Group3 Group4. press K4 3). Put down handset to exit the setting. 5.4 Ring Volume Setting 1)There are three kinds of ring volume(low-range, mid-range and high-range) to choose for you.

This manual is also suitable for:

V-tec

Table of Contents

Save PDF