Cisco 10000 Series Configuration Manual page 197

Chapter 7 4-Port Channelized OC-3/STM-1 Line Card Configuration
AU-4-TUG-3 Controller Interfaces
Use the following procedure to create T1 and E1 interfaces using AU-4-TUG-3 controllers.
The three AU-4-TUG-3 controllers created on a port are based on the same higher order path and do not
Caution
operate independently from one another. In other words, when you "shutdown" any AU-4-TUG-3
controller, the other two controllers on the same SONET port are also shut down.
Enter SONET controller-configuration mode.
Step 1
In this example, the line card is in slot 2.
Router(config)# controller sonet 2/0/0
Router(config-controller)#
Step 2 Use the aug controller command to specify the mode of operation for the STM-1 port (for an AU-4,
three controllers are created).
Router(config-controller)# aug controller au-4-tug-3
Router(config-controller)#
T1 Channel Group Interface over AU-4-TUG-3/TUG-2
a.
b.
c.
E1 Channel Group Interface over AU-4-TUG-3/TUG-2
a.
OL-8834-04
In the following example, the TUG-2 interface is defined as 1 (any number between 1 and 7), the T1
interface is 2 (any number between 1 and 4), and is made up of a single channel group, 5 (any
number between 0 and 23). This channel group consists of all 24 DS0 timeslots.
Router(config-controller)# tug-2 1 t1 2 channel-group 5 timeslots 1-24
Router(config-controller)#
Configure the controller on an STM-4 port. This example shows AU-4-TUG-3 controller #2
configured on port 0for a line card in slot 2.
Router(config-controller)# controller au-4-tug-3 2/0/0.1/2
Router(config-controller)#
Set the container mode to C-11 to establish a T1 interface.
Router(config-controller)# mode c-11
Router(config-controller)#
Create a T1 interface.
In the following example, the TUG-2 interface is 1 (any number between 1 and 7), the T1 interface
is 2 (any number between 1 and 4,) and is defined as a single channel group, 5 (any number between
0 and 23). This channel group consists of all 24 DS0 timeslots.
Router(config-controller)# tug-2 1 t1 2 channel-group 5 timeslots 1-24
Router(config-controller)#
Configure the controller on an STM-4 port.
This example shows AU-4-TUG-3 controller #2 configured on port 0 of a line card in slot 2.
Router(config-controller)# controller au-4-tug-3 2/0/0.1/2
Router(config-controller)#
SDH-Framed Interface Configuration Sample
Cisco 10000 Series Router Line Card Configuaration Guide
7-13