Displaying Interface Information - Cisco 10000 Series Configuration Manual

Chapter 5 24-Port Channelized E1/T1 Line Card Configuration
Simulating Line Card Installation and Removal
You use this hw-module command to simulate installation and removal of a line card at any router
chassis slot you previously referenced using the card command (see the
section on page
Router# hw-module {slot slot reset | subslot slot/subslot reset}
Router#
Example:
Router# hw-module slot 5 reset
This command simulates removal and installation of any line card in router chassis slot 5.
This command does not have a no form.
Displaying Controller Information
You use the show controllers command to display information about an E1 or T1 controller
configuration at any of the 24 line card ports. Use the following syntax for an E1 controller:
show controllers e1 slot/subslot/port
Example 1: The following example shows the output displayed on the system console for line card E1
operation in router chassis slot 1, subslot 0, port 0 when this command executes:
Router# show controller e1 1/0/0
1 1/0/0 is down.
Applique type is Channelized E1 - balanced
Receiver has loss of signal.
Framing is CRC4, Line Code is HDB3, Clock Source is Line.
International Bit: 1, National Bits: 11111
Data in current interval (12 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 12 Unavail Secs
Hardware is C10K CHE1T1 line card
Router#
Example 2: The following example shows the output displayed on the system console for a line card
operating in T1 mode in router chassis slot 1, subslot 0, port 0 when this command executes:
Router# show controller t1 1/0/0
1 1/0/0 is down.
Applique type is Channelized T1 - balanced
Receiver has loss of signal.
Framing is esf, Line Code is ami, Clock Source is Line.
Data in current interval (12 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 12 Unavail Secs
Hardware is C10K CHE1T1 line card
Router#

Displaying Interface Information

You use the show interface command to display information about the current E1/T1 channel-group
(interface) at any of the 24 24-Port Channelized E1/T1 line card ports using the following syntax:
show interfaces serial slot/subslot/port:channel-group [subcommand]
OL-8834-04
5-15):
Cisco 10000 Series Router Line Card Configuaration Guide
Command Descriptions
"Preconfiguring a Line Card"
5-13