Sanyo MIR-162 Service Manual page 35

INCUBATOR COMPONENTS
1. Door:
2. Inner door: It is made of tempered glass. But do not force on the door.
3. Leveling foot: Can be adjusted by screws. When the screw is turned to the right, the leg becomes
shorter.
4. Control panel: Refer to page 10.
5. Separation plate: Do not place objects directly on the plate.
6. Heater box (inside): The heater is attached under separation plate.
7. Gasket: Please be careful not to scratch.
8. Key lock switch: Put the switch to "OFF" when you set the operating condition. After the setting,
put the switch to "ON" to prevent the set condition from changing by accidental contact.
9. Main power switch with circuit breaker: Main switch for all power. When the operation of the unit
is stopped by this circuit breaker, contact with a dealer or a service station after disconnected the power
supply plug.
10. Handle: Pull the knob of inside of the handle to open the door.
11. Shelf support: This can be adjusted to change the height.
12. Shelf: It can be slided forward.
13. Temperature sensor (installation position): Be careful not to allow objects to touch the sensor or
scratch it.
14. Exhaust air vent: During use, the temperature of this section is extremely high; please be careful.
CAUTION
Do not block the air intake vent on the chamber floor by the stocked articles. The blockage can cause
unstable chamber temperature and shorten the heater life.
- 32 -
9