Cdp-Compatible Lldp Configuration Example (Available Only On The Hpe 3100 V2 Ei) - HP 3100 Series Configuration Manual

Number of sent optional TLV
Number of received unknown TLV : 3
# Remove the link between Switch A and Switch B.
# Verify that Ethernet 1/0/2 of Switch A does not connect to any neighboring devices.
[SwitchA] display lldp status
Global status of LLDP: Enable
The current number of LLDP neighbors: 1
The current number of CDP neighbors: 0
LLDP neighbor information last changed time: 0 days,0 hours,5 minutes,20 seconds
Transmit interval
Hold multiplier
Reinit delay
Transmit delay
Trap interval
Fast start times
Port 1 [Ethernet1/0/1]:
Port status of LLDP
Admin status
Trap flag
Polling interval
Number of neighbors
Number of MED neighbors
Number of CDP neighbors
Number of sent optional TLV
Number of received unknown TLV
Port 2 [Ethernet1/0/2]:
Port status of LLDP
Admin status
Trap flag
Polling interval
Number of neighbors
Number of MED neighbors
Number of CDP neighbors
Number of sent optional TLV
Number of received unknown TLV
CDP-compatible LLDP configuration example (available only
on the HPE 3100 v2 EI)
Network requirements
As shown in
IP phone. The two IP phones send out tagged voice traffic.
Figure 67, Ethernet 1/0/1 and Ethernet 1/0/2 of Switch A are each connected to a Cisco
: 0
: 30s
: 4
: 2s
: 2s
: 5s
: 3
: Enable
: Rx_Only
: No
: 0s
: 1
: 1
: 0
: 0
: 5
: Enable
: Rx_Only
: No
: 0s
: 0
: 0
: 0
: 0
: 0
190