Download Print this page

Advertisement

Quick Links

Installation & maintenance
Control equipment
GPRS-modem MC35T
A robust GPRS and dual band GMS modem
with standard interfaces for remote monitoring
and alarm sending.

Product features

• Dual-band EGSM900 and GSM1800
• GPRS multi-slot class 8
• GPRS mobile station class B
• Compliant to GSM phase 2/2+
• Output power
• SIM application tool kit
• Supply voltage range 8V...30V
• Dimensions: 65 x 74 x 33 mm
Data
• CSD up to 14.4 kbps
• USSD
• Non transparent mode
• V.110
• GPRS: max 85.6 kbps (downlink)
• Coding schemes CS1, CS2, CS3, CS4
• PPP-stack
SMS
• Point-to-point MT and MO
• SMS cell broadcast
• Text and PDU mode
Certifi cation
• R & TTE
• GCF approval
Interfaces
• Plug-in power supply
• Handset audio interface
• Mini-Sim Card reader
• Antenna connector FME (male)
• V.24/V.28 interface on the 9-terminal
Sub-D-socket
• Operationg status LED
• Ignition lead on the 6-pin Western connector
Fläkt Woods
8822 GB 2011.09
Scope of supply
• MC35 Terminal
• User guide
Safety information
Radio devices have limitations in the vincinity of
electronic devices:
Switch the TC35 Terminal off when
you are in a hospital or near medical
devices like pacemakers or hearing aids.
The Terminal may interfere with the
operation of these devices.
Swith the TC35 Terminal off when fl ying.
Secure it so that cannot be switched on
inadevertently.
Switch the TC35 Terminal off when you
are near petrol stations, fuel depots,
chemical plants or blasting operations.
The Terminal can disturb the operation of
technical equipment.
Interfaces can occur if the devices is used
near televisions, radios or PCs.
In order to avoid possible damage, we
recommend that you only urse the
specifi ed accessories. These have been
tested and shown to work well with the
Terminal. However, the warranty does not
cover these accessories.
1
Specifi cations are subject to alteration without notice

Advertisement

loading

Summary of Contents for Siemens MC35T

  • Page 1: Product Features

    Installation & maintenance Control equipment GPRS-modem MC35T A robust GPRS and dual band GMS modem with standard interfaces for remote monitoring and alarm sending. Product features • Dual-band EGSM900 and GSM1800 • GPRS multi-slot class 8 • GPRS mobile station class B •...
  • Page 2: Attaching The Terminal

    Installation & maintenance Control equipment The warranty does not apply in the event • Connect a fast 1.25A fuse to the incoming line for of improper use. the positive supply voltage to protect the Terminal. • If a power supply unit is used to supply the TC35 Terminal, it must meet the demands placed on SELV circuits in accordance with EN60950.
  • Page 3: Overvoltage Protection

    Installation & maintenance Control equipment 1. Make sure that there is no voltage applied to the TC35 Terminal. 2. Operate the eject mechanism (yellow pin next to the card holder) to open the card holder by pressing it down with a pen, for example. 3.
  • Page 4 Installation & maintenance Control equipment Interference immunity Transmission type and method • The connecting cable must not exceed 1.8m in • Digitally modulated RF burst signal length. • GMSK in accordance with GSM05.04 • Nominal signal range: ±15V • Half duplex •...
  • Page 5: Operating States / Led

    Installation & maintenance Control equipment Activation of the RS232 control line DTR The TC35 Terminal can be switched on in the same way as via IGT_IN by activating the RS232 control line DTR (high signal). Note The TC35 Terminal is switched on immediately using the recommended plug in power supply unit (see the above explanation on startup).
  • Page 6: Maintenance Tips

    Installation & maintenance Control equipment Standby Software: In the STANDBY state, the TC35 Terminal is ready The command set of the M20 Terminal has been to send and receive and registered in the network. modifi ed and extended for the TC35 Terminal and Paging is performed with the GSM network in is thus not 1:1 compatible.