Log On To The Total Access 5000 - ADTRAN Total Access 5000 Deployment Manual

Total Access 5000 Business Services Deployment Guide

Log On to the Total Access 5000

For initial deployment, only craft access is available. A serial cable with a male DB‐9 connector
on the Total Access 5000 end is required.
To log on to the Total Access 5000 command line interface, complete the following:
1. Set the parameters of the VT100 terminal to the following settings:
2. Plug the male end of the data cable into the Total Access 5000 . Make a connection to the
3. After completing the prerequisite procedures above, pressing any key displays the logon
NOTE
The account name and password are case sensitive.
Default accounts are ADMIN, READONLY, READWRITE, and TEST. The
default password for each of these accounts is PASSWORD. The privilege to
change passwords, account names, and privileges are included in the
ADMIN account.At the Username field, input the Username ( ADMIN ), and
press E
4. At the Password field, input the Password ( PASSWORD ), and press E
5. Upon entering the correct password, the Total Access 5000 CLI introduction banner
6. Type enable , and press E
3-2
• 9600 baud rate
• 8‐data bits
• No parity
• 1‐stop bit
• No flow control
VT100 terminal or a PC running emulation software as appropriate for the equipment.
prompt.
The Total Access 5000 System Logon prompt displays the following information:
User Access Verification
Username:
.
NTER
displays the following information:
User Access Verification
Username:ADMIN
Password:********
Last Login Date
Last Login Type
Login Failures
TA5000>
The Total Access 5000 system displays the following information:
TA5000>enable
TA5000#
: Nov 10 2008 10:19:17
: IP Session(CLI)
: 0 (Since Last Login)
: 14 (Total for Account)
to enable the privileged commands.
NTER
.
NTER
- 192.168.1.3
65K510DEP08-1A