Troubleshooting; Check These Solutions If Your Washer - Samsung 592-29336 Owner's Manual

Will not start . .
 Make sure the lid is firmly closed, check the fuse or reset the
circuit breaker.
 Make sure your Washer is plugged in.
 Make sure the water faucets are on.
 Make sure to press the Power button, then hit the Start/
Pause button, to start your washer.
 Before your Washer starts to fill, it will make a series of
clicking noises to check the door lock and do a quick drain.
(then it is starting if it is doing this)
Has no water or not enough water . .
 Turn both faucets on fully.
 Straighten the water inlet hoses.
 Disconnect hoses and clean screens. Hose filter screens may
be clogged.
There is detergent remains in the automatic dispenser
after the wash cycle is complete .
 Make sure your Washer is running with sufficient water
pressure.Are the faucets open all the way.
Vibrates or is too noisy .
 Make sure your Washer is set on a level surface. If the
surface is not level, adjust your Washer feet to level the
appliance.
 Make sure your Washer is not touching any other object.
 Make sure the laundry load is balanced.
Stops .
 Plug the power cord into a live electrical outlet.
 Check the fuse or reset the circuit breaker.
 Close the lid and press the Start/Pause Button to start your
Washer.
For your safety, your Washer will not spin unless the lid is
closed.
 There may be a pause or soak period in the cycle. Wait
briefly and it may start.
 Check the screens on the inlet hoses at the faucets for
obstructions.
Clean the screens periodically.
Fills with the wrong temperature water .
 Turn both faucets on fully.
 Make sure the temperature selection is correct.
24
F900A WASHER_KENMORE_USER MANUAL_592-29336_DC68-03133N-01_EN.indd 24

TROUBLESHOOTING

Check these solutions if your washer...

 Make sure the hoses are connected to the correct faucets.
 Disconnect the hoses and clean the screens. The hose filter
 While your Washer is filling, you may notice just hot and/
 Press the Start/Pause Button to stop your Washer.
 It may take a few moments for the lid lock mechanism to
 Check the fuse or reset the circuit breaker.
 Straighten the drain hoses. Eliminate kinked hoses. If there is
 Close the lid and press the Start/Pause Button. For your
 Use the High spin speed.
 Use high efficiency detergent to reduce over–sudsing.
 Load is too small. Very small loads (one or two items) may
 Load is too large. Oversized or bulky loads may become
 Check for kink drain hose.
 Make sure all hose connections are tight.
 Make sure the end of the drain hose is correctly inserted and
 Avoid overloading.
 Use high efficiency detergent to prevent over–sudsing.
 Use high efficiency detergent to prevent over-sudsing.
 Reduce the detergent amount for soft water, small or lightly
 Non-HE detergent is NOT recommended.
Flush water lines.
screens may be clogged.
or just cold water going through the dispenser when cold
or warm wash temperatures are selected. This is a normal
function of the automatic temperature control feature as your
Washer determines the temperature of the water.
locked or will not open .
Lid
disengage.
Does not drain and/or spin .
a drain restriction, call for service.
safety, your Washer will not spin unless the lid is closed.
Load is too wet at the end of the cycle .
become unbalanced and not spin out completely.
unbalanced and not spin out completely.
Leaks water .
secured to the drainage system.
Has excessive suds .
soiled loads.
2015/12/15 16:51:43