Wiper And Washer Switch - Mitsubishi L200 Owner's Manual

Instruments and controls

Wiper and washer switch

CAUTION
l
If the washer is used in cold weather, the
washer fluid sprayed against the glass
may freeze, which may hinder visibility.
Warm the glass with the defroster or rear
window demister before using the washer.
Windscreen wipers
3
Except for vehicles equipped with rain sensor
The windscreen wipers can be operated with the ig-
nition switch in the "ON" or "ACC" position.
If the blades are frozen to the windscreen, do not
operate the wipers until the ice has melted and the
blades are freed, otherwise the wiper motor may be
damaged.
3-36
MIST- Misting function
The wipers will operate once.
E00507101191
OFF- Off
INT- Speed sensitive intermittent operation
Interval between wipers varies in accord-
ance with vehicle speed.
LO- Slow
HI- Fast
To adjust intermittent intervals
With the lever in the "INT" (speed-sensitive) posi-
tion, the intermittent intervals can be adjusted by
E00516900303
turning the knob (A).
1- Fast
2- Slow
NOTE
l
The speed-sensitive-operation function of the
windscreen wipers can be deactivated.
For further information, we recommend you
to consult a MITSUBISHI MOTORS Author-
ized Service Point.
OCRE12E1
Misting function
Move the lever in the direction of the arrow and re-
lease, to operate the wipers once.
Use this function when you are driving in mist or
drizzle.
If the lever is held in the upward position (MIST),
the wipers continue operating until the lever is re-
leased.
Vehicles with rain sensor
E00526400369
The windscreen wipers can be operated with the ig-
nition switch in the "ON" or "ACC" position.