Outbound Dynamic Nat Configuration Example (Non-Overlapping Addresses) - HP FlexNetwork MSR2003 Configuration Manual

Local flow-table status: Active
Interfaces enabled with static NAT:
Totally 1 interfaces enabled with static NAT.
Interface: GigabitEthernet2/0/2
Config status: Active
# Display NAT session information.
[Router] display nat session verbose
Initiator:
Source
Destination IP/port: 202.38.1.111/2048
DS-Lite tunnel peer: -
VPN instance/VLAN ID/VLL ID: -/-/-
Protocol: ICMP(1)
Inbound interface: GigabitEthernet2/0/1
Responder:
Source
Destination IP/port: 202.38.1.100/0
DS-Lite tunnel peer: -
VPN instance/VLAN ID/VLL ID: -/-/-
Protocol: ICMP(1)
Inbound interface: GigabitEthernet2/0/2
State: ICMP_REPLY
Application: INVALID
Start time: 2012-08-16 09:30:49
Initiator->Responder:
Responder->Initiator:
Total sessions found: 1
Outbound dynamic NAT configuration example
(non-overlapping addresses)
Network requirements
As shown in
addresses 202.38.1.2 and 202.38.1.3. Configure outbound dynamic NAT to allow only internal users
on subnet 192.168.1.0/24 to access the Internet.
IP/port: 10.110.10.8/42496
IP/port: 202.38.1.111/42496
Figure 64, a company has a private address 192.168.0.0/16 and two public IP
TTL: 27s
5 packets 420 bytes
5 packets 420 bytes
141