Yamaha YK250XGC Installation Manual page 67

Place the cover on the base side.
r
Reattach the cover in the reverse
t
order of detachment.
It is recommended to replace the O-rings
and seals with new ones. If these parts are
not replaced or reattached, the dust/drip
proof performance or the degree of
cleanliness may lower.
For details about the bellows clamp position,
see the Fig. on the right.
Step 14
23224-HM-00
23225-HM-00
Step 15
Rubber
Rubber
Bellows end face
Rubber
Reattach the clamp
so that the projection
part of the clamp shown
in the Photo is located
in the clearance of the
black rubber.
Placing the cover
Place the cover so that
it is not damaged.
Clamp
The bellows end face is flush
with the clamp ring end face.
Clamp ring
Clamp ring
* Install the bellows and clamp at the positions
shown in the Fig. above.
(Tolerance: ±0.5 mm)
Almost this orientation
2
2-19