Trouble Shooting - Arcam AV860 Handbook

trouble-
shooting
Problem Check that...
There are no lights on the unit the power cord is plugged into the Receiver and the mains socket it is plugged
<
into is switched on.
the power button is pressed in.
<
If a red LED is present, the Receiver is in standby mode. Press any button on the
front panel or remote control.
The unit responds erratically or there are fresh batteries in the remote control.
<
not at all to the remote control
the front panel window is visible and you are pointing the remote control
<
towards it.
The front panel display is blank the display hasn't been turned off. Press the
<
or remote control.
No picture is being produced your viewing device is turned on and switched to display your Receiver. Test
<
by pressing the
the main menu screen on your display device.
the correct video input is selected on the Receiver.
<
the video source is on, is operating normally, and is in 'play' mode if
<
appropriate.
There are bright edges or ensure the 'sharpness' control on your display device is switched off or set to
<
'ghosts' on the picture near minimum.
for HDMI connections, try using a shorter cable or alternatively a different
<
brand.
No sound is produced the correct input has been selected.
<
the 'Audio Source' has been set correctly in the 'Input Config. ' menu
<
the source equipment is on, is operating normally and is in 'play' mode if
<
appropriate.
the volume is turned up to a reasonable level and the Receiver is not in mute
<
mode.
The sound is poor or distorted you have not excessively increased the input sensitivity (i.e. reduced the
<
maximum input signal voltage) in the Input Config. menu if an analogue
input is being used.
you have selected the correct size of speakers to suit your system in the setup
<
menu.
E-40
button on the front panel
DISPLAY
button on the Receiver or on the remote and look for
MENU