Toshiba Strata CIX Installation Manual page 26

Software Installation
Strata CIX Database Programming
4. Click on OK.
5. The screen will change to the Full IP Station Assingment (command 260).
6. Enter the first four digits of the MIPU (xIPU) card equipment number (cabinet/slot), do not
enter a port number.
7. In the 01 Type field pull down list, select ATT.
8. Toshiba recommends entering COS 10 for the following:
• COS DAY1=10
•
COS DAY2=10
• COS Night=10
9. For Call Progress Tones assign Dial Tone. This assigns Dial Tone as the tone heard after LCR
access codes are dialed (required).
10. You must create this as a new port. The ATT parameter cannot be changed later. If the DN
already exists it must be deleted and then added as a new ATT port.
DKT Data Assignments
1. Select Station > Station Assignments, click on the Prime DN for this particular Attendant
Console in the list on the right side of the screen.
1. Enter data for the FBs listed below:
p
p
p
2-14
01 – Station Type select "Attendant" from the pull down list (required).
02 – Select the Key Strip Pattern for the Attendant Console (required).
05 – Assign Tone First signaling (required).
Strata CIX PC Attendant Console Installation 06/09