Table of Contents
Advertisement
Very first time power on after installation
The following chapter usually can be skipped, as this has usually already been
done when you received your VISIO 22+. It should not be necessary that you
do this again.
Connect VISIO 22+ power supply to mains.
Press Power button
on left of control unit for about one second or until
lights turn on, monitor should be turned on automatically. (Check for blue
light on bottom of TFT display, a bit right of middle.
Display power button is directly left to light. You can move your finger from
the right bottom edge of Display frame slowly to the left, until you feel the
raised power button. After pressing this button, the blue light will be lit. From
now, VISIO will switch on the Monitor automatically.
The above steps only have to be performed once directly after assembly. In
your daily use from then on, you only have to press the Power button on the
VISIO 22+ control panel.
6
Advertisement
Table of Contents
