Cleaning Thoroughly - Panasonic ES-LV9N Operating Instructions Manual

Cleaning thoroughly

Cleaning with water
• Turn the shaver off and disconnect the AC adaptor.
1
Apply some hand soap and some
water to the system outer foil.
2
Press for more than
2 seconds to activate the sonic
vibration cleaning mode.
• Splashing of foam is suppressed.
• The battery capacity lamps blink in order.
• After about 20 seconds, it will be
automatically turned off, or you can turn
it off by pressing the power switch.
3
Remove the outer foil section
and clean with running water.
• See page 17 for attaching and
removing the outer foil section.
• Splashing is reduced by rinsing the
shaver in sonic vibration cleaning mode.
• After rinsing with water, shake the shaver up and down for a
few times to remove excess moisture and then wipe off any
drops of water with a dry cloth.
16
4
Attach the outer foil section
and dry with the self-cleaning
recharger.
1. Insert the shaver into the self‑
cleaning recharger and plug the
adaptor into a household outlet.
• Check that the charge status
lamp ( ) is glowing.
2. Press twice.
The DRY lamp glows, and the "Dry/Charge" mode will start
after approximately 6 seconds.
• It is possible to change to the "AUTO" mode even after the
"Dry/Charge" mode has started.
Dry
180 min
3. Remove the adaptor after the selected mode is completed.
► Drying the shaver without the self-cleaning recharger
Allow the shaver to dry in the shade,
avoid direct sunlight.
Notes
• Be careful not to hit the main body on the sink or any other object
while draining the water. Failure to do so may cause malfunction.
1
1
2
Charge
0 to 60 min