Zelmer 1600 Instructions For Use Manual page 70

If the safety-valve has opened and it seems to you that the bag is not full yet, we recommend to
exchange the bag because a fine dust must have clogged the bag surface pores, at unfavorable
circumstances, which in turn decreased the vacuum cleaner suction-power significantly. By picking up
wool wastes the bag can be full although the full bag indicator does not respond. In this case you
should also exchange the bag for a new one.
Do not vacuum with no bag inside (you can not put the hose end into the cover hole, if the bag
is not installed).
− Take the hose out of the vacuum cleaner inlet hole.
− Release the catch of the front cover (9) and open it.
− While holding the bag plate (10 ), turn it inwards (A)
a little and then take the whole bag upwards (B).
− Close the SAFBAG bag cover to block out the hole of
the dirty bag.
− Put the plate of the new bag into the guides (11) and
insert it together with the diaphragm down to the bottom
of the container, spread the bag.
Installation direction of the bag is
denoted by an arrow on the bag.
− Close the cover by pressing it until
you can hear a characteristic crack -
be careful not to trap the bag.
This dust bag has been made of a special multi-layer porous material In comparison with a traditional
paper dust bag, it is characterized by much better technological and economical parameters:
− Due to its high plasticity, it fills the vacuum cleaner dust bag
container closely, which makes it possible to absorb a few times
more dust (depending on the size of the vacuum cleaner dust
bag container);
− The span of time between the fitting of a bag and removing it
− increases by 3 times on average, due to which, the use of the
vacuum cleaner becomes more economical;
− It shows much better filtration parameters, which results in:
− more effective dust retention,
− streamlining the airflow (which increases the power of the engine, as
well as its durability),
− the vacuum cleaner still retaining a high suction power, even though
the bag is being gradually filled up,
− a significant increase in health protection, as the, outcoming air is much better filtered;
− hygienic operation due to a closed single use bag;
− the material of which the bag was made has acquired all the ecology-related certificates.
H OW TO EXCHANGE THE INLET FILTER
1 1 7 B
− Open the vacuum cleaner as before the bag exchange.
− Draw the inlet filter (12) out of the
body. Install a new one making sure
the outside edge of the filter is inside
from the limiting rib (A) and close the
vacuum cleaner.
70
S A F B A G ― S
PACE
A F
CTION ILTRATION
BAG
Set of SAFBAG-s
No. 49.4120
Fold line
Cover