Sensors; Unbalanced Load Detection System; Aqua-Sensors; Cleaning And Maintenance - Siemens WM..U... Instruction And Installation Manual

Switching the drum-care information
signal on/off
You can touch position 4 and use the +
button to switch the ä Drum Clean
information signal on or off.
Possible setting values:
0 off
1 on
H

Sensors

U nbalanced load detection
S e n s o r s
system
The automatic unbalanced load
detection system detects imbalances
and ensures even distribution of the
laundry by repeatedly starting and
stopping drum spinning.
If the laundry is extremely unevenly
distributed, the spin speed is reduced
or the spin cycle is not performed for
safety reasons.
Place large and small items of
Note:
laundry evenly in the drum.

Aqua-Sensors

During the rinse cycle the Aqua sensor
checks the degree of turbidity (turbidity
is caused by dirt and detergent residue)
of the rinsing water. The duration and
the number of rinse cycles depend on
the turbidity of the water.
2
Cleaning and
maintenance
:
Warning
C l e a n i n g a n d m a i n t e n a n c e
Risk of death!
There is a risk of electric shock if touch
live components.
Switch off the appliance and pull out the
mains plug.
Caution!
Fire and explosion hazard!
Toxic vapours can be produced by
cleaning agents that contain solvents,
e.g. cleaning solvent.
Do not use cleaning agents that contain
solvents.
Caution!
The appliance may be damaged!
Cleaning agents that contain solvents,
e.g. cleaning solvent, can damage
surfaces and components in the
appliance.
Do not use cleaning agents that contain
solvents.
Appliance housing/control
panel
Remove the detergent residue
■
immediately.
Wipe the housing and the control
■
panel with a soft, damp cloth.
Do not use abrasive cloths, sponges
■
or detergents (stainless steel
cleaner).
Do not clean the appliance with a
■
water jet.

Drum

Use chlorine-free cleaning agents, do
not use steel wool.
If there are odours in the appliance, or
to clean the drum, run the ä Drum
Clean 90 °C programme without
laundry.
Sensors
en
25