Removing The Battery - Segway NINEBOT ONE S1 User Manual

12

Removing the Battery

WARNING
Removing a battery can be dangerous. You risk personal injury from electric shock. If you are not
comfortable removing the battery yourself, please contact your dealer/distributor or email Segway at
technicalsupport@segway.com.
The standard Ninebot One S1 (with a capacity of 310 Wh) has two batteries, one on either side.
Removing one battery reduces the power, range, and weight of the Ninebot One S1. For your safety,
the speed is limited when only one battery is installed. Please ride carefully.
Power switch
Battery
Compartment
16
Battery
Compartment
Install in the reverse order of removal.
Remove the rubber plug Open the battery cover
1 2
BA TT .O
PE N
P o w e r o f f t h e v e h i c l e a n d Use a Phillips-head screwdriver
disconnect the charger. Then to remove the two screws. Then,
remove the rubber plug on the with a firm tug, use your hand to
side of the vehicle. lift and remove the battery cover.
4 Remove the screws 5 Install the battery cover
Use a Phillips-head screwdriver to Press down firmly on the edges of
the battery cover to snap it in
remove the four battery screws as
shown. place. Start at the top and work to
the bottom. Be careful not to
pinch any wires.
Disconnect the wires
3
A wire
B wire
Unplug the black wire (A) first,
then unplug the yellow wire (B).
Pull the connector firmly. Do not
pull on the wire itself or you may
damage it.
Install screws and plug
6
BA TT .O
PE N
Use a Phillips-head screwdriver
t o i n s t a l l t h e b a t t e r y c o v e r
screws, then press the rubber
plug into place.
17