Panasonic DP-180 Network Scanner Operations page 17

2
Drum/Toner Unit
To replace the Toner Cartridge only:
5
Drum
Clean the excess toner
with a soft cloth.
(ATTENTION)
● Be careful not to scratch the surface of the Drum Unit (Green),
and not to touch it with bare hands.
9
New Toner
Cartridge*
Drum Unit
13
Front Cover
GENERAL PARAM.(0-9)
17
ENTER NO. OR ∨ ^
Press "5" and SET Keys.
5: Drum Replacement
3
Drum/Toner Unit
For replacing the Drum Unit:
6
Protective Sheet
New Drum Unit
For replacing the Toner Cartridge only:
10
Cleaner
Each 3 Time
Drum/Toner Unit
Cleaner is included in the
Toner Cartridge.
NOTE:
Keep this Cleaner for feature use.
When Toner Cartridge has
14
been replaced.
NEW TONER REPLACED?
1:YES 2:NO
1: Select "1: YES" if a new toner
cartridge was installed.
2: Select "2: NO" in all other
cases.
When Drum Unit is replaced.
18
DRUM REPLACEMENT?
1:YES 2:NO
1
Press "1" Key.
2
Press RESET Key on the Control Panel.
1
To replace the Toner Cartridge:
Perform steps (4 - 14). (Skip step 6)
2
To replace the Drum Unit:
Perform steps (4 - 18).
(Skip steps 5, 7 and 10)
3
To replace the Toner Cartridge
and Drum Unit:
Perform steps (4 - 18).
7
Shake
10-15 times
Tape and Protective Cover
(ATTENTION)
● Do not remove the
protective cover unless you
are ready to use it.
11
Drum/Toner Unit (New)
Place the Drum/Toner Unit
over the Guide Rails and
insert it until it stops.
15
Following steps (15 - 18) for
Drum Replacement only:
If set in other function
mode, press the COPY Key.
Press the FUNCTION Key on
the Control Panel.
4
8
12
16
17