Mounting The Device On A Din Rail; Mounting The Device To A Panel - Siemens RUGGEDCOM RX1511 Installation Manual

Chapter 2
Installing the Device
NOTE
For detailed dimensions of the device with either DIN rail or panel hardware installed, refer to
Chapter 5, Dimension
The following sections describe the various methods of mounting the device:
• Section 2.1.1, "Mounting the Device on a DIN Rail"
• Section 2.1.2, "Mounting the Device to a Panel"
Section 2.1.1

Mounting the Device on a DIN Rail

For DIN rail installations, the RX1511 can be equipped with panel/DIN rail adapters pre-installed on each side of
the chassis. The adapters allow the device to be slid onto a standard 35 mm (1.4 in) DIN rail.
To mount the device to a DIN rail, do the following:
1. Align the adapters with the DIN rails and slide the device into place.
Figure 2: DIN Rail Mounting
1. Panel/DIN Rail Adapter
2. Install one of the supplied screws on either side of the device to secure the adapters to the DIN rails.
Section 2.1.2

Mounting the Device to a Panel

For panel installations, the RX1511 can be equipped with panel/DIN rail adapters pre-installed on each side of the
chassis. The adapters allow the device to be attached to a panel using screws.
To mount the device to a panel, do the following:
1. Place the device against the panel and align the adapters with the mounting holes.
6
Drawings.
2. DIN Rail 3. Screw
3
2
1
Mounting the Device on a DIN Rail
RUGGEDCOM RX1511
Installation Guide
1
2