Charging - Hitachi uc18yg Handling Instructions Manual

CHARGING

Before using the power tool, charge the battery as follows.
1. Connect the charger's power cord to the receptacle.
2. Insert the battery in the charger
Position the battery so that the nameplate faces toward the nameplate of the charger and
press in the battery until it comes into contact with the bottom plate (See Fig. 1).
Inserting the battery will turn on the charger (the pilot lamp lights up).
Battery (EB912S, EB9S, FEB9S,
EB914, EB914S, EB9B, EB924)
Battery (EB712S, EB7S,
FEB7S, EB714S, EB7B)
CAUTION
If the pilot lamp does not light up, pull out the power cord from the receptacle and
check the battery mounting condition.
The pilot lamp goes off to indicate that the battery is fully charged.
CAUTION
If the battery is heated due to direct sunlight, etc., just after operation, the charger
pilot lamp may not light. At that time cool the battery fi rst, then start charging.
Battery (EB12S, FEB12S, EB12B, EB1224)
Battery (EB1212S, EB1214L, EB1214S,
EB1220BL)
Nameplate
Fig. 1
11
Battery (EB1412S, EB1414,
EB1414S, EB14B, EB1424)
Battery (EB1812S,
EB1820)
Battery (EB1814SL,
EB1820L, EB1824L)
Hole for connecting the battery
Pilot lamp
English