Philips 3122 785 14580 Service Manual page 9

4.3.6 Audio Panel
Figure 4-8 Audio panel
1. Disconnect all cables from the Audio panel.
2. Remove all mounting screws (1) from the Audio panel.
3. Take out the Audio panel.
4.3.7 Side I/O Panel
1. Disconnect the cable from the Side I/O panel.
2. Release the clamps and take out the Side I/O panel from
its bracket.
4.3.8 Top / Side Control
1. Remove the mounting screws from the Top / Side Control
panel bracket.
2. Disconnect the cable.
3. Release the clamps and take out the Top / Side Control
panel.
4.3.9 LED Panel
1. Disconnect all cables from the LED panel.
2. Remove the mounting screws from the LED panel.
3. Take out the LED panel.
4.3.10 Speakers
1. Remove all mounting screws.
2. After removing the cover plate, you can access the
speakers.
3. Be sure that the foam that makes the unit airtight is not
damaged.
Mechanical Instructions
1
F_15460_070.eps
140405
FTP2.4E AA
4.3.11 SSB
2b
2a
Figure 4-9 SSB top shielding
3
Figure 4-10 Connector plate
Figure 4-11 SSB removal
1. Remove the LVDS locking bracket (1).
2. Remove all fixing screws (2).
3. Disconnect the grounding wire from the mains filter (2a).
4. Shift, and lift the shielding at the top. The panel hinges at
the SCART side.
Caution: do not damage the EMC shielding foam while
you remove the shielding.
5. Remove mounting screws (3) from the connector plate.
Use a 5 mm socket screwdriver to remove both DVI
connector distance bolts (4).
6. Remove the mounting screws from the SSB (5).
7. Disconnect the LVDS cable (6).
8. Lift the SSB, disconnect all cables, and take out the SSB.
4. EN 9
1
2
F_15460_069.eps
140405
4
E_14620_031.eps
7
6
5
F_15460_067.eps
130405
130504