Locating The Power Feed Cable For Your Electricity Meter (Se) (No) (Fi) - Efergy e2 User Manual

Safety
You should under no circumstances connect a sensor to a cable if any of the cables lead-
ing to the meter is damaged in any way. No cables need to be cut. Do not clip any cables.
Do not break any seals or such on the meter.
Contact your local electricity supplier if you are at all uncertain about connecting the
sensor to the correct cable. All work inside distribution boxes/consumer units must
be carried out by competent electricians.
5.2 Locating the power feed cable of your
electricity meter (SE) (NO) (FI)
The Efergy electricity monitor is installed by clamping the sensor clips around the incoming mains
power cables leading to your electricity meter.
Locating your electricity meter/distribution box
Find out where your meter is located. It is normally found on an outer wall, in the garage, in the
cellar or in a utility room. If you live in a flat, it may be located near the entry door, in the stairway,
or in the cellar. Make sure the cables exiting the bottom of the electricity meter are accessible.
Modern homes and flats can have safety panels which protect the cables entering the meter.
These are often sealed. Under no circumstances should the seals be broken other than by
a competent electrician. Instead, we recommend that the sensors be fitted after the main
switch in your distribution box.
If you still feel unsure as to how to mount the sensor, we recommend that you contact a qualified
electrician.
9