Hitachi C 10FL Instruction Manual And Safety Instructions page 13

ASSEMBLY THE TABLE EXTENSION (FIG. C)
1. Place the left table extension next to the saw
table, aligning the mounting holes (1).
2. Place bolts (2) and thread in mounting holes.
3. Place a straight edge or combination square on
the saw table, across the table extension.
4. Adjust the mounting bolts (2) until the extension
is flush with the saw table. Tighten.
5. Repeat these procedures for the right extension
table.
Fig. C
2
ASSEMBLY THE FRONT AND REAR TABLE RAIL
(FIG. D, E)
NOTE: Front of table rails assemblies are different.
Assembly the front rail (Fig. D)
1. Attach the right front side cover (1) into right front
table rail (2). Repeat for the left front rail.
2. Place the hex. bolts M8-20 (3), hex bolts M8-16 (4)
through the holes at the front table edge. Screw the
square nuts (5) onto each bolts.
NOTE: Keep the bolts and square nuts loosened
before front rail fixed.
3. Attach the right front rail onto proper location by
having the square nuts pass through the slot of the
front rail. Repeat for the left front rail.
4. Attach the middle plug (6) to connect the two half
front rail. (Fig. E)
5. When the blade was installed, use the rip fence and
gauge to adjust the front rail to proper location. When
the front rail is level with table, then fix the front rail
by tightening the six bolts.
Fig. D
4
5
6
Assembly the rear table rail (Fig. E)
6. Attach the side covers (1) and middle plug (2) to the
7. Place the rear table rails on the saw table, aligning
8. Place the bolts (4) and tread in the holes; tighten the
1
BLADE RAISING HANDWHEEL (FIG. F)
Thread the blade handwheel handle (1) into blade
raising handwheel (2) and tighten.
BLADE TILTING HANDWHEEL (FIG. F)
1. Attach the blade tilting handwheel (3) to the elevation
2. Attach and tighten the dome nut (4) at the end of the
3
BLADE GUARD ASSEMBLY (FIG. G, H)
To avoid injury from an accidental start, make sure
the switch is in the OFF position and the plug is
disconnected from the power source outlet.
4
When installing the blade guard, cover the blade teeth
with a piece of folded cardboard to protect
2
yourself from possible injury.
1
Never operate this machine without the safety guard in
place for all through sawing operations.
– 13 –
rear table rails (3).
with the holes in each rail.
bolts and check the alignment again.
Fig. E
screw at the front of the saw.
shaft.
Fig. F
2
1
3 4
WARNING
English
4
3
1
2