Table of Contents
Advertisement
Serial Port Use
If you forgot the password or address, you can check it or write a new one it to communi-
cate to the Network board by using a serial port (RS232C).
Service Setting
To enter the Service Mode
1
Turn the monitor on.
2
Press and hold the Position Up (e) button
on the monitor and press the Status but-
ton on the remote control unit to appear
the Dealer Mode Menu.
Dealer Mode Menu
3
Disconnect and connect the output cable
of the Network Board. The Network Board
begins entering the service mode and it
takes about 1 minute.
To exit the Service Mode
Disconnect and connect the AC plug from
the monitor.
42
Dealer Mode Menu
Front key lock
0
Input
0
Max volume
0
On Screen Display
0
0
MENU
Initial setup
0
Remote control
0
OK
–
+
MENU
INPUT
VOLUME
Position Up (e) Button
Status Button
4
Advertisement
Table of Contents
