Related Manuals for DeWalt DE6242
Summary of Contents for DeWalt DE6242
- Page 1 WALT Tel: 01753 567055 210 Bath Road Fax: 01759 572112 Slough, Berks. www.dewalt.co.uk SL1 3YD DE6242 01/06 Copyright D WALT...
- Page 2 IFU 087.5 Cutting to Length for 45° Joints only ADDITIONAL EQUIPMENT REQUIRED: • ELECTRIC HAND ROUTER When producing a male joint, left or • right handed and where the worktop 30mm ROUTER GUIDE BUSH turns through 45°, the position of the 1000mm •...
-
Page 3: Protecting The Environment
You can check the location of your nearest authorised repair agent at the address indicated in this manual. For the final finishing cut, position Alternately, list of authorised DEWALT repair agents and full details of our after-sales service and contacts the router again in the far left side of the slot, and set the router to cut at the full depth of the worktop. - Page 4 DOWN (see diagram T) If your DEWALT product becomes defective due to faulty materials or workmanship within 12 months of the 4. Slide the jig along the length of the worktop so date of purchase, we will guarantee to replace all defective parts free of charge or, at our discretion, replace...
- Page 5 Left Hand 45° Male Joints Safety Notes Before starting ……... 1. MALE JOINT Prepare the male worktop with the laminate face down. • Insert 2 pins in holes marked ♂ 45°. DIAGRAM Q Never cut worktop to length until all joints are complete and have been checked for correct fit.
- Page 6 Left Hand 45° Female Joints 90° Female Joints - Left Side FEMALE JOINT Refer to the diagrams DIAGRAM M on the different joints available. For 45° joints FEMALE JOINT Refer to the diagrams DIAGRAM A FEMALE JOINT- the jig should always be placed with the logo on the different joints available.
- Page 7 Cutting to Length for 90° Joints only 90° Male Joints - Left Side 1. MALE JOINT Prepare the male worktop with the laminate or prepared surface face When producing a male joint, left or right handed DIAGRAM D down. and where the worktop turns through 90°, the posi- MALE JOINT—...
-
Page 8: Female Joint
90° Female Joints - Right Side 90° Male Joints - Right Side 1. FEMALE JOINT Refer to the DIAGRAM G diagrams on the different joints avail- 1. MALE JOINT Prepare the male FEMALE JOINT - able. Prepare the female worktop worktop with the laminate face up.