Hitachi C 10FR Instruction Manual page 11

SAW MOUNTED TO WORK SURFACE (FIG. B)
1. If the leg set will not be used, the saw must be
properly secured to a sturdy workbench using the
four mounting holes at the base of the saw.
2. The surface of the table where the saw is to be
mounted must have a hole large enough to facilitate
sawdust fall-through and removal.
3. Square the saw on the mounting surface and mark
the location of the four 3/8" (9.5mm) mounting holes
(1).
4. Drill 3/8" (9.5mm) hole into the mounting surface.
5. Mark an 11" (279.4mm) square (2) centered between
the four mounting holes (1).
6. Cut out and remove the square.
7. This opening will allow sawdust to fall through the
saw base.
8. Place the saw on the work surface, and align the
mounting holes of the saw with those drilled through
the surface.
9. Fasten the saw to the work surface.
WARNING
Do not operate this machine on the floor. This is
very dangerous and may cause serious injury.
Fig. B
SQUARE
CUTOUT
WARNING
Failure to provide the sawdust fall-through hole will
cause sawdust to build up in the motor area, which may
result in fire or cause motor damage.
KEEPING THE AREA CLEAN
1. Sawdust and wood chips that fall from under the saw
will accumulate on the floor.
2. Make it a practice to pick up and discard this dust
when you have completed cutting.
ADJUSTING THE CUTTING LINE INDICATOR (FIG. C)
1. Take off the cover (1) by loosening screws (2).
2. Adjust the pointer (3) to align to the blade.
3. Mount the cover on the table to fix the pointer.
NOTE: The pointer was set up to align to the right
side of the blade when packing.
Fig. C
3
INSTALLING BATTERY FOR LED LIGHTING SPACE
(FIG. D)
1. Open the cover (1) of battery box on the top of blade
2. Install 2 pieces of 1.5V 3A batteries into the battery
3. Close the cover.
4. Turn on the switch (2) to check the LED lighting.
BLADE RAISING HANDWHEEL (FIG. E, F)
1. Attach the handwheel (1) to the elevation screw (2)
2. Attach and tighten the dome nut (5) at the end of the
2
1
BLADE TILTING HANDWHEEL (FIG. F)
1. Attach the other handwheel (6) to the blade tilting
2. Attach and tighten the handwheel dome nut (5).
1
2
– 11 –
guard.
box in right direction.
1
Fig. D
at the front of the saw. Make sure the slots (3) in the
hub of the handwheel engage with the pins (4).
(Fig. E)
shaft (Fig. F).
Fig. E
3
1
screw on the side of the saw in the same manner as
above.
Fig. F
English
2
4
2
5
6