Assembly And Adjustments - Hitachi C 10FR Instruction Manual

English

ASSEMBLY AND ADJUSTMENTS

ESTIMATED ASSEMBLY TIME 25~40 MINUTES
FOLDING THE STAND (FIG. A-1)
1. Release the stand hook (1).
2. Unfold the wider leg set (2). Pull the lever (3)
downward and push it to lock in place. Then, put
down the wider leg set on the ground.
3. Lift the stand up and unfold the narrower leg set (4).
4. Pull the lever downward and push it to lock in place.
NOTE: Make sure the stand is locked securely.
Fig. A-1
11
10
2
3
ASSEMBLING THE ROLLER WHEEL (FIG. A-1)
Attach the roller wheel (7) to roller wheel bracket using
square neck bolt (8) and nut (9) as shown.
INSTALLING THE DUST BAG (FIG. A-1)
1. Place the dust bag (6) around the neck of the dust
chute and tie the dust bag by pulling the string tight
and secure with the spring-loaded tie clip.
NOTE: Do not use this saw to cut and sand metal.
The hot chips or sparks may ignite sawdust or the
bag material.
ASSEMBLING TABLE SAW TO STAND (FIG. A-1,A-2)
1. Place stand on level surface and adjust front right
adjustable stand pad (5) to make stand stable.
2. Place table saw on the top of stand aligning holes in
base with holes in s tand.
3. Insert four hex. head bolts (6) through flat washer
and holes in base and s tand.
4. Tighten all four bolts .
1
7
8
9
4
5
6
– 10 –
NOTE: Do not over tighten bolts holding saw to
stand. This will damage the saw base.
5. Carefully set the saw in its upright position on a
clean level surface.
6. Thread the support rod (10) into the socket (11) at the
rear of stand. Adjust the adjustable foot (12) properly.
Fig. A-2
OFF ON
6
FOLDING THE TABLE SAW/STAND (FIG. A-1, A-3)
1. Release the lever of the narrower leg set and keep
the lever on top. Hold the table and lift the saw up just
above the ground and fold up the narrower leg set.
NOTE: The narrow leg set can be held by a "spring
clip".
2. Then reposition on the saw onto the ground. Release
the lever of the wider leg and keep the lever on top
set then fold the leg set up into position.
3. Then fix the legs with stand hook.
SETTING UP THE TABLE SAW/STAND (FIG. A-3)
1. Release the stand hook.
2. Unfold the wider leg set and lock the lever in place.
3. Put down the wider leg set on the ground, lift the saw
up and unfold the narrower leg set.
4. Pull the lever downward and lock into place.
NOTE: Make sure the saw is locked in position
securely before operation.
FOLDING
Fig. A-3
1
SET-UP
1 2
6
12
2
3