Cleaner Maintenance; Emptying The Dust Container - Hoover SPRINT EVO Instruction Manual

USING yOUR CLeANeR
1. Extract power cord and plug it into the power supply. do not pull the cord beyond
the red marker. [5]
2. Adjust the telescopic tube* to the desired height by moving the telescopic tube
adjuster up and raise or lower the hose handle to the most comfortable cleaning
position. [6]
3. Select the type of surface to be cleaned by pressing the pedal in the nozzle. [7]
hard Floor – Brushes are lowered to protect the floor.
Carpet – Brushes are raised for the deepest clean.
4. Switch the cleaner on by sliding the on-off control to the on position. [8]
5. Vary the suction as desired by closing or opening the suction regulator* on the hose
handle. [9]
6. Switch off at the end of use by pressing the on/off button. [8] Unplug and press the
cord rewind button to wind the power cord back into the cleaner. [10]
7. To store your cleaner, park the nozzle in the parking slot at the rear of the cleaner
main body. [11]
ACCeSSORIeS
All accessories can be fitted to the hose handle or the end of the tubes.
2 in 1 tool combines several functions into one tool:
Crevice tool – For corners and hard to reach areas. [12]
dusting Brush – For bookshelves, frames, keyboards and other delicate areas. [13]
pet hair remover mini turbo nozzle* - Use the mini turbo nozzle on stairs or for deep
cleaning on textile surfaces and other hard to clean areas. Particularly suitable for pet
hairs removal. [1X]
allergen remover mini turbo nozzle* – Use the mini turbo nozzle on stairs or for
deep cleaning on textile surfaces and other hard to clean areas. Particularly suitable for
allergen removal. [1Y]
hard Floor nozzle* – For parquet floors and other delicate floors. [1Z]
important: do not use the mini Turbo nozzles on rugs with long fringes, animal hides
and carpet pile deeper than 15mm. do not keep the nozzle stationary while the brush is
rotating.

CLeANeR MAINTeNANCe

CLeANeR MAINTeNANCe

Emptying the dust Container

when the dust reaches the max level indicator on the container, empty the dust container.
important: To maintain optimum performance, do not allow the dust to sit higher than
the max level.
1. release the dust container by sliding the dust container release button towards the
front of the cleaner. Lift the dust container from the cleaner main body. [14]
2. Before emptying the dust Container, gently tap it against the side of a bin to release
any excess dust from the filter.
3. To empty the dust Container, hold the dust Container over a bin with one hand and
use the other hand to press the dust Container flap Opening Button to release the
dust into the bin. [15]
4. Close the dust Container Flap and refit the dust Container to the cleaner main body.
Cleaning the washable filters
The cleaner is fitted with a pre-motor and exhaust filter. To maintain optimum cleaning
performance, regularly clean the filters. remove excess dust from the filters by gently
tapping them against the side of a bin. The filters should be washed after every 5
container empties.
IMPORTANT: All bagless cleaners require regular filter cleaning. Failure to clean
your filters may result in air blockage, overheating and product failure. This may
invalidate your guarantee.
To access the Pre-Motor filter:
1. empty the dust Container as described in 'emptying the dust Container'. Then,
keeping the dust Container Flap open:
2. remove the pre-motor filter by rotating it clockwise at the bottom of the dust Con-
tainer. [16]
Separate the protective mesh from the filter. [17] Gently tap both the protective
3.
mesh and the filter against the side of a bin to remove excess dust and wash both
of them under warm water. [18] do not use hot water or detergents.
4. remove excess water from the filter and leave it to dry fully before reusing. [21]
5. once the filter is fully dry, reassemble the filter pack (protective mesh and filter) and
refit to cleaner.
Important: do not use the product without the pre-motor filter pack fitted.
important: Always ensure the filter packs are fully dry before use.
2
gB
*Certain Models Only
** May vary depending on model