Advertisement
Advertisement
Table of Contents
Related Manuals for Hoover SPIRIT Spirit Vacuum Cleaner
Summary of Contents for Hoover SPIRIT Spirit Vacuum Cleaner
- Page 2 Fill in and retain! The HOOVER vacuum cleaner you have just purchased is a combina- tion cleaner. It has a nozzle for carpet and floor cleaning and cleaning tools for above the floor cleaning. The model and serial number appear on the bottom of the cleaner.
-
Page 3: Save These Instructions
Close supervision is necessary when any appliance is used by or near children. Do not allow vacuum cleaner to be used as a toy or to run unattended at any time. Do not use cleaner to pick up matches, or live ashes and cigarette butts. - Page 4 Unpacking Unpack the cleaner from the carton and identify the parts shown. Remove and dispose of the cardboard packing. A. Canister cleaner B. Rug and floor nozzle C. Throw away bag D. Extension wands, hose and cleaning tools The cleaner assembled will look like the 11 I...
- Page 5 1. Combination rug and floor nozzle each model) 2. Carrying handle * 3. Bag check indicator shows red when throw away bag should be checked. 4. Cover is removed by lifting up top section of carrying handle and pulling forward. 5.
-
Page 6: How To Assemble
How to assemble I. Connect hose To connect hose, insert large end into opening of cleaner, lining up largest projection on hose with largest notch of opening. Turn hose to the right to tighten. To disconnect, depress latch, and turn hose to the left. 2.Attach extension wands, cleaning tools and nozzle To attach the extension wand to... -
Page 7: How To Use
How to use Rug and floor nozzle The combination rug and floor nozzle has been designed to do an effi- cient cleaning job on both carpet and hard surface floors. Refer to the section that shows the rug and floor nozzle that you have purchased. - Page 8 Hard surface floors Put the brush in the stationary position by moving the brush lock lever to “FLOOR” on the nozzle. Rugs Put the brush in floating position by moving the brush lock lever either to the left or right to “RUG”.
-
Page 9: Edge Cleaning Feature
Hard surface floors Put the brush in the stationary position by pushing in the lever marked “FLOOR” with your toe until you hear a click. Rugs Put the brush in the floating posi- tion by pushing in the lever mark- ed “RUG”... -
Page 10: Suction Regulator
Suction regulator (Available with some models) The suction regulator is located on the hand grip and may be used to increase or decrease suction for various cleaning tasks. Set the suction regulator to MINI- MUM, MEDIUM or MAXIMUM suction by rotating the plastic ring until the raised plastic indi- cator on the dial is directly under the desired setting. -
Page 11: Cleaning Tools
Those tools which do not come with your model are available at a nominal cost from your Authorized Hoover Dealer, a Hoover Factory Service Center or bv writina to The Hoover Company, North Canton, Ohio44720. ’... -
Page 12: To Clean Stairs
To clean stairs Clean stairs by placing the cleaner on end as pictured in the illustra- tion. Clean stairs from bottom to top. How to store Your cleaner may be stored on end as shown in the illustration. Store the hose, wands and nozzle separately or attached to the cleaner. - Page 13 Where to buy bags Bags may be purchased from your local Authorized Hoover Dealer or from a Hoover Factory Service Center. When ordering bags, be sure to give the model number of your cleaner. What bags to buy Use HOOVER bag type K with this cleaner.
-
Page 14: Secondary Filter
3. To install the new bag, place. the notches on the bag collar (at the bag,edge) into the grooves in- side the lower front of cleaner. 4. Pull collar forward until latch snaps onto collar. Open folds of bag. Replace cover. Secondary filter To clean secondary filter from... -
Page 15: Rug And Floor Nozzle
Rug and floor nozzle To maintain the cleaning effectiveness of your rug and floor nozzle, the brushes and litter pickers (on some models) will need replaced occa- sionally. Refer to the section that shows the rug and floor nozzle that you have purchased. - Page 16 Replacing rug/f loor nozzle brush When to replace Replace the brush on the rug and floor nozzle when it becomes worn and is not doing a satisfac- tory job of cleaning. How to replace Brush Lock Lever must be in “RUG”...
- Page 17 Replacing brush and litter picker on rug/f loor nozzle LITTER PICKER ’ When to replace Replace the brush and litter picker on the rug and floor nozzle when they become worn and are not doing a satisfactory job of cleaning. How to replace 1.
-
Page 18: If You Have A Problem
Warranty provided with this product. Do not send your cleaner to The Hoover Company in North Canton for service as this will only result in delay. Always identify your cleaner by model number when requesting informa- tion or ordering replacement parts. -
Page 19: Energy Saving Tips
HOOVER bag made for your model cleaner. Turn off cleaner when not in use, such as when moving furniture. Keep your cleaner operating at peak performance level - have inspec- tion and service performed by a Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer. - Page 20 VCMA This information has been compiled by the Vacuum Cleaner Manufacturers Associ- ation from Government and Private Sources concerned with product safety. These basic guidelines are for your pro tee tion and convenience. TO AVOID ELECTRIC SHOCK Never vacuum damp or wet surfaces or liquids.
Need help?
Do you have a question about the SPIRIT Spirit Vacuum Cleaner and is the answer not in the manual?
Questions and answers