Electrical Connection; Air Inlet And Exhaust Connection; Gas Connection - Miele PT 8301 SL Operating Instructions Manual

Installation and connection

Electrical connection

The electrical components of this dryer comply with
IEC 335-1 and IEC 335-2-11.
The electrical connection may only be carried out by
a suitably qualified technician in accordance with
local and national safety regulations.
Please observe the wiring diagram supplied.
Please ensure that the voltage and frequency of the
dryer as quoted on the data plate comply with the
on-site supply.
Connection should be made via a suitable isolator
which complies with local and national safety
regulations and in accordance with the wiring rules
and which is easily accesible for disconnecting the
dryer from the electricity supply. Provision must be
made on-site to switch off all poles. Switches with a
minimum all-pole contact gap greater than 3 mm are
suitable for isolating the appliance. These include
circuit breakers, fuses and relays (IEC/EN 60947).
If the appliance is disconnected from the electricity
supply, ensure adequate measures are taken to
ensure that the appliance cannot be reconnected to
the electricity supply until all work has been carried
out.
After the dryer has been connected to the electricity
supply, check the phase rotation on the incoming
power supply to the appliance.
If the mains connection cable is damaged, it must be
replaced by the manufacturer, its service agent or
similar qualified persons in order to avoid a hazard.
Equipotential bonding
Equipotential bonding must be carried out if required.

Air inlet and exhaust connection

This dryer must only be used when it is connected to
a suitable ducting system. The installation site must
be adequately ventilated. See the installation
instructions supplied.
24

Gas connection

This work must be carried out by an authorised
person in accordance with local and national safety
regulations. See the installation instructions supplied.
,
The earth lead (N) and phase conductor (L)
must be connected to the correct connectors.
Take care not to connect them the wrong way
round!
The gas group to which the dryer has been set at the
factory is given on the Gas Data label on the rear of
the dryer.
If the appliance is converted for a different gas
group, or to liquid gas, a conversion kit is required.
This is available from the the Miele Spare Parts
Department. When ordering, please quote the model
and serial number of the appliance, as well as the
gas type, group and connection pressure in the
country of installation.
Please follow the installation instructions carefully. To
ensure safety, any conversion work must only be
carried out by an authorised technician.
,
Do not attempt to repair or work on gas-heated
appliances yourself. Repairs must only be carried
out by an authorised technician to ensure safety.
In the event of a fault please contact the Miele
Professional Service Department.
,
After setting up and connecting the appliance,
ensure that all outer casing parts are correctly
fitted back into position.