Cub Cadet 19A30003100 Operator's Manual page 12

7. Open Hood by pushing in on the rear, right-side tab with
your right hand, as seen in 1 of Fig. 4-16, and lifting the cover
with your left hand in the center rear of the bagger cover, 2.
2
8. Install both grass bags onto the bag support assembly by
inserting the front edge in first (1), as seen in Fig. 4-17,
and setting the back edge down (2) until it fits into the
assembly.
9. Install one of the rubber chute straps onto the chute elbow
using one of the supplied clevis pins (711-05063), washer (736-
0204) and Bow-tie cotter pins (714-04040) from hardware
pack 689-00092B. See Fig. 4-18. Secure the end of the strap
utilizing the hole furthest from the end, insert the torsion
spring hook (732-04510A) into the other end.
10. Install the deck mounting pin (711-05049) up into the chute
elbow using two flat washers (736-0176) from hardware pack
689-00092B and secure with a flange lock nut (712-3027), as
seen in Fig. 4-18.
12 s 4 — a
ectiOn sseMbly
1
Figure 4-16
1
2
Figure 4-17
& i
nstallatiOn
11. Install the shoulder bolt (738-0754) into the chute elbow
from the top side and secure inside the chute elbow using
a flange lock nut (712-04063) from the same hardware pack
(689-00092B). See Fig. 4-18.
Figure 4-18
12. Install a grass-catcher pin (911-04069) from hardware pack 689-
00092B into the hole provided in the upper portion of the
chute elbow and secure with a flange lock nut (712-3027). See
Fig. 4-19.
Figure 4-19