Connecting To Your Computer Via Usb; Installing The Usb Driver; Connecting The Rc-202 To A Computer; Usb Function Settings - Boss RC-202 Owner's Manual

Connecting to Your Computer via USB

If you use a USB cable to connect the
RC-202's USB port to a USB port on your
computer, you'll be able to do the following
things.
USB mass storage
You can back up RC-202 tracks (WAV files) to your
computer or load WAV files from your computer to the
RC-202.
USB audio/MIDI
You can play your computer's sounds through the
RC-202, or record the RC-202's sounds into your
computer. You can also use USB MIDI to synchronize the
RC-202's tempo to a DAW running on your computer.
Reference
For more about the RC-202's USB settings, refer to
"Parameter Guide" (PDF).

Installing the USB Driver

In order to use the RC-202's USB audio/MIDI
functionality, you must first install the USB driver in your
computer (USB mass storage will work even if you don't
install the USB driver).
1.
Install the USB driver in your computer.
You can download the RC-202's dedicated driver from
the BOSS website.
BOSS website
http://www.boss.info/support/
For details on operating requirements, refer to the BOSS
website. The program and procedure for installing the
driver will depend on the system you're using. Carefully
read the downloaded Readme.htm file before you
proceed.
Connecting the RC-202 to a
Computer
1.
Use a USB cable to connect the RC-202's USB
port to your computer's USB port (a connector
that supports USB 2.0 Hi-Speed).
NOTE
5 This might not work correctly on some types of
computer. Refer to the BOSS website for details on
the supported operating systems.
5 Use a USB cable that supports USB 2.0 Hi-Speed
operation.
14

USB Function Settings

You can specify the USB output destination. For details,
refer to "Parameter Guide" (PDF).
USB audio flow
RC-202
USB Audio Routing
Same output sound as the
OUTPUT jacks
Using USB to Exchange Files with
Your Computer (USB Mass Storage)
You can connect the RC-202 to your computer via a USB
cable, and back up RC-202 tracks (WAV files) to your
computer or load WAV files from your computer to the
RC-202.
Playable WAV file formats
Data Format
Bit Depth
Sampling Frequency
Maximum size per WAV file is 2 GB, maximum time is
approximately 3 hours.
1.
Press the [SETUP] (EXIT) button.
2.
Press the [SLICER] (USB) button.
3.
Press the [VALUE] knob to select "MD."
4.
Turn the [VALUE] knob to select "msg."
5.
Press the [SETUP] (EXIT) button.
6.
Use a USB cable to connect the RC-202's USB
port to your computer's USB port (a connector
that supports USB 2.0 Hi-Speed).
When the connection to the computer is completed, the
message ". . ." appears.
* You can't make USB connections if the RC-202 is not
stopped, or if there is a phrase that has not been
saved.
LINE OUT
SUB MIX
LOOP IN
To Looper
WAV
16-bit linear, stereo
44.1 kHz