Fuses; Replacing The Headlights; Servicing The Battery - Toro 07253TC Operator's Manual

Fuses

There are three fuses in the machine's electrical
system. They are located beneath the bed in a box on
the right hand side of the frame (Fig. 33).
Fuses: Ignition System—10 amp.
Lights—10 amp.
Power Point—10 amp. (15 amp. max.)
Figure 33
1. Ignition system
2. Lights
3. Power point
4. Open

Replacing the Headlights

Specification: GE Headlight # H7610
1. Set the parking brake, turn the ignition off, and
remove the key.
2. Reach beneath the dash and push the headlight out
of the hood.
3. Remove the screws attaching the wire harness to
the headlight.
4. Remove the rubber seal from around the headlight
(Fig. 34). Discard the headlight.
5. Align the notch on the inside of the seal with the
notch on the new headlight (Fig. 34). Slide the
seal onto the headlight until the seal is firmly in
place.
3
2
31
2
Figure 34
1. Rubber seal
2. Inside notch—align with notch on headlight
3. Outside notch align with notch in hood
4. Headlight
6. Attach the headlight to the wire harness using the
previously removed screws.
7. Align the notch on the outside of the seal with the
notch in the hood. Push the headlight and seal into
the hood until it is firmly in place.
Note: Applying soapy water to the outside of the
seal may aid in sliding the seal into the hood.

Servicing the Battery

WARNING
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals known
to the State of California to cause cancer and
reproductive harm. Wash hands after handling.
Important Do not jump start the vehicle.
Service Interval/Specification
Always keep the battery clean and fully charged. Use
a paper towel to clean the battery and battery box. If
the battery terminals are corroded, clean them with a
solution of four parts water and one part baking soda.
Apply a light coating of grease to the battery terminals
to prevent corrosion.