Operating The Ez-Remote Control System - Toro EZ-Remote User Manual

Operating the EZ-Remote Control System

Please note the following operating characteristics of the EZ-Remote system:
The GreenKeeper 212 control dial should be in the
When the EZ-Remote is used to operate the controller, all automatic and manual controller opera-
tions are suspended. For example, if an automatic watering cycle should occur during a remote
control operation, the watering cycle will be skipped. The EZ-Remote enables any station to be
selected and operated for 10 minutes of run time regardless of the station's program assignment.
Only one station at a time can be operated.
For optimum range, the transmitter should be operated from a location in which a direct, unrestrict-
ed view of the receiver is possible. The distance between the transmitter and receiver under these
conditions may be approximately 160' – 300' (49 m – 91 m). The operating range may be signifi-
cantly reduced by interference due to obstructions and/or other site conditions.
The transmitter is preset to operate up to 12 controller stations, but is adjustable from one to 64
stations. For best results, the maximum station number set should match the number of controller sta-
tions being used. To adjust this number, refer to "Adjusting the Maximum Station Number" on page 7.
The transmitter and receiver are preset to the same address code enabling signal communication
without additional set up. To select an alternate or universal address code, refer to "Changing the
Address Code" on page 8.
Each time a command is sent to the receiver, an antenna icon
To conserve battery power, the transmitter display screen will automatically turn off approximately
10 seconds after pressing any button.
To operate a station:
• Press the transmitter
• Press the
ON
6
or button until the desired station number is displayed.
button to start the station. The station will run for 10 minutes, then shut off.
position when operated remotely.
RUN
will be displayed.