NEC Express5800/R320a-E4 User Manual page 74

3-8 Linux Setup and Operation
[List of RAID Arrays]
Nam Partition
e
=======================================================
=====
< Mirroring Array (RAID1)>
md0 /boot
md1 swap
md2 /
md3 /var/cras
h
(Perform restoration (RECOVERY) to each RAID devices (md).
After a while, check the Status with the below command.
"RESYNC" shows it is waiting to be restored. "R" is displayed
on the left side of the Member. This indicates the disk
partition is either waiting to be restored or is in the process
of restoring.)
Command action
1 List RAID Arrays
2 List Internal Disks
3 Make Mirroring Arrays
4 Repair Mirroring Arrays (RAID1)
5 Delete Mirroring Arrays (RAID1)
6 Remove Disk Partitions (RAID1)
7 Make Striping Array
8 Delete Striping Array
c Configurations
q Quit
Command: 1
Nam Partition
e
=======================================================
=====
< Mirroring Array (RAID1)>
md0 /boot
md1 swap
md2 /
md3 /var/cras
h
(When the each RAID device Status is DUPLEX, the RAID
configuration is restored normally.
replacement procedure.)
(Label Status
)
( - ) RECOVERY
(62%)
( - ) RESYNC
( - ) RESYNC
( - ) RESYNC
(RAID1)
(RAID1+0)
(RAID1+0)
(Label Status
)
( - ) DUPLEX
( - ) DUPLEX
( - ) DUPLEX
( - ) DUPLEX
Member
(1)sda1 R(9)sdi1
(1)sda2 R(9)sdi2
(1)sda3 R(9)sdi3
(1)sda5 R(9)sdi5
Member
(1)sda1 R(9)sdi1
(1)sda2 R(9)sdi2
(1)sda3 R(9)sdi3
(1)sda5 R(9)sdi5
This ends the disk