Charging The Drone; Optional Blade Guards; Repairing Damaged Blades - sky viper v2400hd Flying Manual

v2400hd
STREAMING VIDEO DRONE
CONTENTS
• Streaming Video Drone
• Alternative Pro Thumbsticks
• Screwdriver
• Rechargeable 3.7v 650mAH LiPo Battery
• Screws • Remote Control
• 4 Blade Guards
• 4 Replacement Blades
• USB Charging Cable
• Phone Mount

CHARGING THE DRONE

1 Disconnect battery wires. Push down the battery
box holder on the rear side of the drone. Pull battery
box out of underside of drone.
Disconnect battery wires
CHARGING PRECAUTIONS:
• After use, allow drone (battery on bottom) to cool down to room
temperature before charging again.
• Charge drone in an isolated area, away from excessive heat
or moisture.

OPTIONAL BLADE GUARDS

Blade guards are great for beginning pilots and can be
easily installed if desired. The guards add undesired
weight and reduce flight performance. Blade guards are
optional and should not be used with advanced flight
sensitivity setting 3. To attach blade guards, insert the
posts of the blade guards into the holes of the drone.
Press in the posts to lock into place.
ALTERNATIVE
PRO THUMBSTICKS
• Lift joystick upward to
remove.
• Insert thumbstick into
stem to replace.
2 Plug charging cord into computer or USB
power block. Once charged, disconnect
battery from USB charging cable.
Push down Pull battery box out
•
•

REPAIRING DAMAGED BLADES

1 Unplug battery on drone.
2 Make note of the blade color and letter
MAINTENANCE
•
BATTERIES AND MAINTENANCE
REMOTE BATTERIES
Loosen the screw in
the Remote Control
battery compartment
door with a Phillips
screwdriver and insert
batteries as shown.
Replace door and
tighten screw.
Plug in USB cable
Red light = charging
Green light = fully charged
If you suspect that the battery is damaged or swelling, turn off the
drone immediately.
Do not modify, heat, or wet the battery in any way. Only recharge with
provided charger.
(A or B) before removing the blade
from drone. (Markings are located on
the underside of blades and Drone).
3
4
Over time, loose hair or carpet fibers may get wound in blades, reducing
performance. Unplug the Drone and remove fibers from motors. (Remove
blades if necessary)
Online Video
Instructions & Flying
Tips available now at
SKYVIPER.COM
3 x1.5 V AAA (LR03)
3 Insert LiPo battery into back of drone.
Reconnect the battery wires.
Plug into charging wire
3 Remove the small screw using
the mini screwdriver provided.
4 Replace the damaged blade
with a new blade with matching
color and letter. Secure the
blade with the retaining screw.
BLACK
BLADES
B
A
B
GREEN
BLADES
A