sky viper NANO DRONE Flying Manual

DASH
NANO DRONE
POWERING UP AND PAIRING REMOTE
OFF ON
Turn the drone on. (Be sure that
drone is completely charged.
See reverse.)
FLIGHT BASICS
To make flying easier, place the drone on the ground in front of you
with the drone facing away from you (green blades forward). You
should be facing the same way the drone is facing.
L
Press LAUNCH to automatically launch a few feet off the ground.
Move LEFT (Throttle) thumbstick up or down to make drone fly
higher or lower and left or right to rotate.
Use RIGHT (Directional) thumbstick to fly forward,
backward, left or right.
Press LAND to automatically land.
Alternatively you can use the left thumbstick to land
the drone. Hold the left thumbstick all the way down
for about 2.5 seconds after the drone has safely
reached the ground, and the motors will stop spinning.
AUTO AND MANUAL FLIGHT MODES
AUTO mode is best for new
pilots. Begin by pressing the
LAUNCH button for takeoff.
The drone will hold its altitude,
and gradually fly up or down
when you press up or down on
the left thumbstick.
MANUAL mode is better for
experienced pilots. When the
left thumbstick is pushed all
the way up the drone will spin
its motors as fast as it can
while maintaining stability, and
when the left thumbstick is
pushed all the way down the
motors will stop spinning
completely.
01942
Place the drone on level surface for
calibration.
R
LAUNCH
LAND
L
R
LAUNCH
L R
LAUNCH
LAND
L R
LAUNCH
LAND
L
R
LAUNCH
LAND
Turn on controller. (Before initial use,
install new batteries into controller.
See Reverse.)
FLIGHT CONTROLS
Up
Rotate
Rotate
Right
Left
Down
Stunt Button
Power
Rotation Trim
Auto Mode Indicator
Flight Mode
Manual Mode Indicator
• Reset controller to
factory settings:
Hold F Trim, B Trim,
and Power for
3 seconds.
If for any reason you need to immediately stop the drone, hold down the stunt
button (for drones that don't have a stunt button, use the video button) and
move both thumbsticks down and away from the center of the controller.
ONE TOUCH STUNTS
NOTE:
R
Once a stunt has been initiated, DO NOT adjust Throttle or press any other controls until the stunt has been completed.
BARREL ROLL LEFT OR RIGHT
L AUNCH
While flying forward (or reverse), tap the STUNT button.
L A ND
FLIP IN 4 DIRECTIONS
1 Bring the drone to a mid-air hover without flying in any
direction. Remove finger from the RIGHT thumbstick.
2 While hovering, press and hold the STUNT button.
3 Then quickly tap the RIGHT thumbstick in the direction
you want the drone to flip.
CAUTION!
The drone should be flying at least 6 feet in the air with a minimum clearance of 6 feet in all directions before
attempting stunt functions.
REPLACING DAMAGED BLADES
Using a fork or tool,
gently pry the blade
from the motor shaft.
FLYING GUIDE
When LEDs turn solid, the drone is ready to fly.
Fly Forward
Fly Left
Fly Backward
LAUNCH/LAND BUTTON
PRESS TO LAUNCH PRESS TO LAND
Fly Right
Forward/
Backward Trim
Left/Right Trim
To change the speed of
the drone, hold STUNT,
, and . The LED on
the controller will blink
once for slow, twice for
medium, and three
times for fast.
Front
A B
B A