Page 1
YEPP Model Name : YP-Q1 Model Code : YP-Q1JEW/XEE YP-Q1JAW/XEE SERVICE Manual YEPP CONTENTS 1. Precaution 2. Product Specification 3. Disassembly & Reassembly 4. Troubleshooting 5. Exploded View & Part List 6. PCB Diagram 7. Schematic Diagram YP-Q1 Refer to the service manual in the GSPN (see the rear cover) for the more information.
5. You should not put any object or liquid into product. Otherwise, it may cause failure or mal-operation. 6. If replacement material is required, service engineer should use materials with the same standard. The use of non-standardized materials may cause failure of product. Samsung Electronics...
4. Minimize physical operation when handling with the ESD device for replacement without packing (Otherwise, namely friction between cloth fibers or lifting of the foot from the carpet floor may cause static electricity enough to damage the ESD device). Samsung Electronics...
- Over 30 hours of music / 4 hours of video playback possible Elegant Lighting Effect - Spectacular colored lighting created by expert lighting designer The Part of Art (Color LED Effect) - Product designed by expert lighting designer (ex: Ingo Maurer, EON SLD etc.) Samsung Electronics...
Video : Max. 4hours (Brightness 5, Volume: 15,Normal Sound Mode) Temperature Range for -5 ~ 35˚C (23 ~ 95˚F) Operation Case Plastic Weight Dimensions (WxHxD) 51 x 98 x 10.9 mm FM Frequency 87.5 ~ 108.0MHz FM Signal to 55dB Noise Ratio FM T.H.D FM Useable 38dB Sensitivity Samsung Electronics...
BACK to press it in a downward direction and remove it. 2) Slowly lift one side of the ASS’Y WINDOW-LCD and remove it starting at the tape on both sides. TOUCH-PAD 1) Remove the ASSY’ WINDOW- LCD’s TOUCH-PAD FPCB from the CONNECTOR. Samsung Electronics...
Page 11
3 Check the right side ventilation groove. 4 Use the tweezers to remove it from the hook. 2) Use the upper part’s ventilation groove to remove the LCD-MODULE. 1 Use the upper left ventilation groove to remove the GROUND SHRRT. Samsung Electronics...
Page 12
Disassembly & Reassembly Part Name Description Description Photo CABINET- 1) Remove the 6 screws. MIDDLE :PH (PI2.5),+,M1.4,L3.5,ZPC (BLK) MAIN-PCB 1) Carefully pick up the MAIN PCB and remove the BATTERY CONNECTOR. 2) Remove the BATTERY and the MAIN PCB. Samsung Electronics...
Be careful not to short anything out when checking the power line. The power does not turn on. After insert battery to PCB, Is battery inserted to Main PCB Please TEST normally? Does the power turn on after recharging the battery? Completion Samsung Electronics...
Page 16
Check 7WH74_IC301 the DODC_EN is ‘HIGH’. Refer to wave pattern image of Fig. 4-1. Check the power terminal connection Check MAIN 12Mhz clock (Battery, Adapter) Check power at the BATTERY Defective (single part). Completion Recheck after replacing the battery. Samsung Electronics...
Page 18
Are there skips and Check if IC701 is shorted. noises? Are the skips and noises even when playing another file? Does the same symptom persist even after upgrading the firmware to the latest version? Replace the BOARD (needs thorough examination). Samsung Electronics...
Page 22
Check No Power 4-1-1 Check C312 on 3.4V Does the same Replace LCD symptom persist even after Check CON802 LCD replacing the LCD? B-to-B connector Refer to wave pattern image of Fig. 4-4. Replace the BOARD (needs thorough examination). Samsung Electronics...
Page 26
BOOT Update be “Unknown Device” show “My Computer” as a performed with FWDN in Device Manager? portable device? (Recovery tool)? Recheck after installing the driver. Can formatting be Is it accessible? Defective done in Explorer? Completion Samsung Electronics 4-13...
2. Check the contents of the folder that was decompressed. 3. Connect the YP-Q1 to the PC. 4. Open the Removable Disk folder of the YP-Q1. 5. Select the installation file in the folder that was decompressed, and then copy the upgrade files to the Removable Disk folder of the YP-Q1.
Page 28
1. If you use FWDN program for the first time, you should install VTC driver on your computer. 1) Before executing FWDN, execute intall2000XP. (FWDN\Driver\install2000XP) 2) Connect YP-Q1 to PC by using USB cable. 3) Execute FWDN and open ROM file. 4) With the power on, press the RESET button on the back.
Page 29
Troubleshooting 5) New hardware finding wizard appears. Tick "Software Setting Automatically" and click NEXT. 6) Wait for finding. 4-16 Samsung Electronics...
Page 30
Troubleshooting 7) Press "Continue Anyway" button. 8) Press "OK" button. 9) Press "Browse..." button. 10) Select FWDN\Driver\vtcdrv.sys then OK and Finish. Samsung Electronics 4-17...
Page 31
2 Set the Q1.RSC file (FNT, .AUI, .IMG) path. Generally, it is in the same location as the ROM file. Set the other conditions referring to the table on the side. When the settings are complete, click the Apply button and the OK button. 4-18 Samsung Electronics...
Page 32
Troubleshooting 2) You can see WRITE(START) the button is activated. Click it. Then Firmware’s going to download. Samsung Electronics 4-19...
Page 33
3. Finishing 1) Turn on the device. You can see the message "Upgrading Firmware" then the device turns down. 2) Turn on the YP-Q1’s power again. After the "Upgrading firmware (5/5)" message finally appears at the bottom of the booting screen, turn it off and see if the device operates properly.
Exploded View & Part List 5. Exploded View & Part List 5-1 Exploded View ..................5-2 5-2 Electrical Part List ................5-4 Samsung Electronics This Document can not be used without Samsung’s authorization.
Exploded View & Part List 5-1 Exploded View AA001 AC000 AA053 AC040 AK200 AA250 AC357 AW120 AS040 AA900 This Document can not be used without Samsung’s authorization. Samsung Electronics...
Page 36
AH63-01778A CUSHION-LCD;YP-Q1,PORON,T03,W42.9,L58.9, AK200 AH64-04762D KNOB-HOLD;YP-Q1,PC,T1.0,W2.5,L12.0,-,WHI AS040 6003-001166 SCREW-TAPTITE;CH,+,B,M1.4,L4,NI PLT,SWRC AW120 AH64-04759D WINDOW-LCD;YP-Q1,PMMA,T1.5,W48.04,L95.8, BATTERY AH43-00020A BATTERY;354142,YP-Q1,Li Polymer,640mAh AH07-00235A LCD;-,YP-Q1,-,40.34x56.40x0.7,262K AH92-02900G ASSY PCB;MP3,YP-Q1 ASSY PCB,16G,RDS PCB-MAIN AH92-02900E ASSY PCB;MP3,YP-Q1 ASSY PCB,4G,RDS Samsung Electronics This Document can not be used without Samsung’s authorization.
FET700 0505-002229 FET-SILICON;FDMA1028NZ,N,20V,3.7A,0 C605 2203-006423 C-CER,CHIP;100nF,10%,6.3V,X5R,0603 FET801 0505-001930 FET-SILICON;MCH3319,P,-12V,-2.6A,MA C606 2203-006423 C-CER,CHIP;100nF,10%,6.3V,X5R,0603 IC300 1203-005277 IC-DC/DC CONVERTER;MAX8819,QFN,28P, C607 2203-006423 C-CER,CHIP;100nF,10%,6.3V,X5R,0603 C608 2203-006423 C-CER,CHIP;100nF,10%,6.3V,X5R,0603 IC301 0801-002767 IC-CMOS LOGIC;7WH74,D FLIP-FLOP,SSO IC400 0902-002194 IC-MICROPROCESSOR;TCC780,192MHz,FBG 1 C609 2203-006423 C-CER,CHIP;100nF,10%,6.3V,X5R,0603 This Document can not be used without Samsung’s authorization. Samsung Electronics...
Page 38
R401 2007-000157 R-CHIP;47Kohm,5%,1/16W,TP,1005 S/W300 3408-001141 SWITCH-SLIDE;4V DC,0.3A,1,1-pole 3- R403 2007-008516 R-CHIP;10Kohm,5%,1/20W,TP,0603 S/W301 3404-001324 SWITCH-TACT;50mA,12VDC,0.3gf,3.9x2. R404 2007-008516 R-CHIP;10Kohm,5%,1/20W,TP,0603 TR801 0504-001193 TR-DIGITAL;KRC408V,NPN,100MW,22K/47 R405 2007-008516 R-CHIP;10Kohm,5%,1/20W,TP,0603 USBGASKET AH63-01789A GASKET;YP-Q1,REMARK,T0.5,W3.8,L14.3 R410 2007-008516 R-CHIP;10Kohm,5%,1/20W,TP,0603 VAR800 0406-001267 DIODE-TVS;Rclamp0521P,6/-/-V,100W,S Samsung Electronics This Document can not be used without Samsung’s authorization.
Page 39
AH98-00019A ASSY PACKING-SET;-,YP-Q1,ASSY PACKI SNA AH63-01285A SHEET-REMOVER;YP-K3,pet0.1,-,-,-,-, SNA AH69-02361A PACKING-SET;YP-Q1,PAPER,MANILA,0.4, AH69-02362A CUSHION-SET;YP-Q1,PAPER,T1.0,W127,L AH07-00235A LCD;-,YP-Q1,-,40.34x56.40x0.7,262K AH43-00020A BATTERY;354142,YP-Q1,Li Polymer,640 AH68-00508U LABEL SERIAL;COMMON,ELS,-,-,90,-,-, 0.1 SNA AH68-00511G LABEL-SEAL;YP-Z5F,-,ART PAPER,-,-,- AH68-02148D LABEL-LCD;YP-Q1,GUOPENG,PET,0.1,42. AH68-50119B LABEL-EAN(B);-,-,ART,T0.05,W27,L47, 1.05 SNA AH69-01816A CARTON-MASTER;YP-Z5F,-,-,-,-,-,-,-, 0.1 SNA AH97-02943A ASSY;TOUCHPAD,YP-Q1,Assy This Document can not be used without Samsung’s authorization. Samsung Electronics...
Schematic Diagram 7. Schematic Diagram 7-1 Overall Block Diagram ..................7-2 7-2 POWER ......................7-3 7-3 CPU PWR & MEM INF ..................7-4 7-4 CPU ........................7-5 7-5 MEMORY ......................7-6 7-6 AUDIO ....................... 7-7 7-7 24PIN I/O, Interface ..................7-8 Samsung Electronics This Document can not be used without Samsung’s authorization.
Need help?
Do you have a question about the YP-Q1 and is the answer not in the manual?
Questions and answers