Operating The Throttle; Operating The Ignition Switch; Using The Fuel-Shutoff Valve; Starting And Stopping The Engine - Toro 74906 Operator's Manual

Operating the Throttle

The throttle control can be moved between Fast and Slow
positions (Figure 15).
Always use the fast position when turning on the mower deck
with the blade-control switch (PTO).

Operating the Ignition Switch

1. Turn the ignition key to the Start position
When the engine starts, release the key.
Important: Do not engage the starter for more
than 5 seconds at a time. If the engine fails to
start, allow a 15 second cool-down period between
attempts. Failure to follow these instructions can
burn out the starter motor.
Note: Additional starting cycles may be required
when starting the engine for the first time after the fuel
system has been completely without fuel.
2. To stop the engine, turn the ignition key to the stop
position.

Using the Fuel-Shutoff Valve

The fuel-shutoff valve is located under the seat. Move the
seat forward to access it.
Close the fuel-shutoff valve for transport, maintenance, and
storage.
Ensure that the fuel-shutoff valve is open when starting the
engine.
G008946
Figure 15
(Figure
G008947
Figure 16
1
2
1. On
Starting and Stopping the
16).
Engine
Starting the Engine
1. Raise the ROPS up and lock into place, sit on the seat
and fasten the seat belt.
2. Move the motion controls to neutral-locked position.
3. Set the parking brake; refer to Setting the Parking
Brake.
4. Move the blade-control switch (PTO) to the Off
position (Figure
5. Move the throttle lever midway between the Slow and
Fast positions.
19
G008948
Figure 17
2. Off
18).