How To Install Using Isoflex Connectors - Britax safe-n-sound Instructions For Installation & Use

HOW TO INSTALL USING ISOFLEX CONNECTORS

USING ISOFLEX AND TOP TETHER
CONNECTORS
A. With the restraint upright, remove both ISOFLEX
connectors from storage location on the rear of the
restraint by lifting the cover flap as shown. Close
the cover flaps.
B. Recline to rearward facing mode as shown on
page 31.
C. Press and hold the ISOFLEX adjuster release
button and pull the connector strap to fully
lengthen. Repeat for both connector straps.
D. Place the restraint in the desired location on
the vehicle seat between the two ISOFIX low
anchorages with the child seat against the vehicle
seatback.
The stabilising bar need not be in contact with
the vehicle seat back but must be extended and
latched.
36
Instructions for Installation & Use
C
A
D