Adding Fuel; Checking The Cooling System - Toro 30410 Operator's Manual

1. Park the machine on a level surface. Unlock the
engine cover latches.
2. Open the engine cover.
3. Remove the dipstick, wipe it clean, install the
dipstick into the tube, and pull it out again. The oil
level should be up to the Full mark (Figure 5).
Figure 5
1. Dipstick
4. If the oil is below the Full mark, remove the fill cap
(Figure 6) and add oil until the level reaches the Full
mark. Do not overfill.
Figure 6
1. Oil fill cap
5. Install the oil fill cap and dipstick.
6. Close the engine cover and secure it with the latches.

Checking the Cooling System

Service Interval: Before each use or daily
Check level of coolant at the beginning of each day.
Capacity of system is 2-3/4 U.S. gallons (10.4 l).
1. Carefully remove the radiator cap and expansion
tank cap (Figure 7).
If the engine has been running, the pressurized,
hot coolant can escape and cause burns.
• Do not open the radiator cap when the
engine is running.
• Use a rag when opening the radiator cap,
and open the cap slowly to allow steam to
escape.
2. Check the coolant level in the radiator. The radiator
should be filled to the top of the filler neck and the
expansion tank filled to the Full mark.
1. Expansion tank
3. If the coolant is low, add a 50/50 mixture of water
and ethylene glycol anti-freeze. Do not use water
only or alcohol/methanol base coolants.
4. Install the radiator cap and expansion tank cap.

Adding Fuel

Use only clean, fresh diesel fuel or biodiesel fuels with
low (<500 ppm) or ultra low (<15 ppm) sulfur content.
The minimum cetane rating should be 40. Purchase
fuel in quantities that can be used within 180 days to
ensure fuel freshness.
Fuel tank capacity: 19 US gallons (72 l)
Use summer grade diesel fuel (No. 2-D) at temperatures
above 20° F (-7° C) and winter grade (No. 1-D or
No. 1-D/2-D blend) below that temperature. Use of
winter grade fuel at lower temperatures provides lower
18
Figure 7