Toro 29645 Operator's Manual
Toro 29645 Operator's Manual

Toro 29645 Operator's Manual

50cm mulching/rear bagging/side discharge lawn mower
Hide thumbs Also See for 29645:

Advertisement

Quick Links

50cm Mulching/Rear Bagging/Side Discharge Lawn
Mower
Model No. 29645-Serial No. 315000001 and Up

Introduction

This rotary-blade, walk-behind lawn mower is intended
to be used by residential homeowners or professional,
hired operators. It is designed primarily for cutting grass
on well-maintained lawns on residential or commercial
properties. It is not designed for cutting brush or for
agricultural uses.
Read this information carefully to learn how to operate and
maintain this machine properly and to avoid both injury and
damage to the machine. You are responsible for operating the
machine properly and safely.
You may contact Toro directly at www.Toro.com for product
and accessory information, help finding a dealer, or to register
your product.
Whenever you need service, genuine Toro parts, or additional
information, contact an Authorized Service Dealer or Toro
Customer Service and have the model and serial numbers of
your machine ready.
Figure 1
model and serial numbers on the machine. Write the numbers
in the space provided.
1. Model and serial number plate
Model No.
Serial No.
© 2014-The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
identifies the location of the
Figure 1
Register at www.Toro.com.
This manual identifies potential hazards and has safety
messages identified by the safety alert symbol
which signals a hazard that may cause serious injury or death
if you do not follow the recommended precautions.
1. Safety alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical information
and Note emphasizes general information worthy of special
attention.
This product complies with all relevant European directives.
For details, see the separate product specific Declaration of
Conformity (DOC) sheet.
Net Torque: The gross or net torque of this engine was
laboratory rated by the engine manufacturer in accordance
with the Society of Automotive Engineers (SAE) J1940.
As configured to meet safety, emission, and operating
requirements, the actual engine torque on this class of mower
will be significantly lower. Go to www.Toro.com to view
specifications on your mower model.
Do not tamper with the engine controls or alter the governor
speed; doing so may create an unsafe condition resulting in
personal injury.
Contents
Introduction .................................................................. 1
Safety ........................................................................... 2
General Lawn Mower Safety ..................................... 2
Sound Pressure ...................................................... 3
Sound Power .......................................................... 3
Hand/Arm Vibration .............................................. 4
Safety and Instructional Decals ................................. 4
Setup ............................................................................ 5
1 Attaching the Handle............................................. 5
Guide................................................................. 5
3 Filling the Engine with Oil...................................... 5
4 Assembling the Grass Bag ...................................... 6
Product Overview .......................................................... 7
Original Instructions (EN)
All Rights Reserved *3388-478* A
Printed in the USA
Form No. 3388-478 Rev A
Operator's Manual
(Figure
Figure 2
2),

Advertisement

Table of Contents
loading

Summary of Contents for Toro 29645

  • Page 1: Table Of Contents

    This manual uses 2 words to highlight information. Important calls attention to special mechanical information You may contact Toro directly at www.Toro.com for product and Note emphasizes general information worthy of special and accessory information, help finding a dealer, or to register attention.
  • Page 2: Safety

    • Specifications ............7 Keep in mind that the operator or user is responsible for Operation ..............7 accidents or hazards occurring to other people or their Attachments/Accessories......... 7 property. Filling the Fuel Tank ..........8 • Understand explanations for all pictograms used on the Checking the Engine-Oil Level........
  • Page 3: Sound Pressure

    To ensure the best performance and safety, • Stop the blade if the machine must be tilted for purchase only genuine Toro replacement parts and transportation when crossing surfaces other than grass accessories. Do not use will fit parts and accessories;...
  • Page 4: Hand/Arm Vibration

    Hand/Arm Vibration CAUTION Long-term exposure to vibration while operating Measured vibration level for right hand = 1.8 m/s the machine may cause some numbness in the Measured vibration level for left hand = 2.5 m/s hands and wrists. Uncertainty Value (K) = 1.2 m/s Wear gloves that dampen the vibration whenever you operate the machine for an extended period of Measured values were determined according to the procedures...
  • Page 5: Setup

    Setup 3. Move the handle to the operating position (Figure and tighten the 2 handle knobs as tightly as you can. Important: Remove and discard the protective plastic 4. Loosen the upper handle knob, move the upper handle sheet that covers the engine. to the operating position (Figure 3), and tighten the...
  • Page 6: Assembling The Grass Bag

    2. Remove the dipstick (Figure 5) and pour about 3/4 of the crankcase capacity of oil into the oil-fill tube. Note: Max. fill: 0.47 L (16 oz), type: 10W-30 or SAE 30 detergent oil with an API service classification of Assembling the Grass Bag SJ or higher.
  • Page 7: Product Overview

    A selection of Toro approved attachments and accessories is available for use with the machine to enhance and expand its capabilities. Contact your Authorized Service Dealer or Distributor or go to www.Toro.com for a list of all approved attachments and accessories.
  • Page 8: Filling The Fuel Tank

    Filling the Fuel Tank 1 cm (1/2 inch) DANGER Gasoline is extremely flammable and explosive. A fire or explosion from gasoline can burn you and others. • To prevent a static charge from igniting the gasoline, place the container and/or machine directly on the ground before filling, not in a vehicle or on an object.
  • Page 9: Adjusting The Cutting Height

    Note: The cutting height settings are 25 mm (1 inch); 38 mm 4. Insert the dipstick into the oil-fill tube, but do not screw it in. (1-1/2 inches); 51 mm (2 inches); 64 mm (2-1/2 inches); 76 mm (3 inches); 89 mm (3-1/2 inches); and 102 mm (4 inches). 5.
  • Page 10: Mulching The Clippings

    Check the grass bag frequently. If it is damaged, install a new Toro replacement bag. WARNING The blade is sharp; contacting the blade can result in serious personal injury.
  • Page 11: Operating Tips

    • For best performance, install a new blade before the cutting season begins. • Replace the blade when necessary with a Toro replacement blade. Cutting Grass • Cut only about a third of the grass blade at a time. Do not...
  • Page 12: Maintenance

    Maintenance Note: Determine the left and right sides of the machine from the normal operating position. Recommended Maintenance Schedule(s) Maintenance Service Maintenance Procedure Interval • Change the engine oil. After the first 5 hours • Check the engine oil level. Before each use or daily •...
  • Page 13: Servicing The Air Cleaner

    Servicing the Air Cleaner Service Interval: Every 25 hours/Yearly (whichever comes first)—Replace the air cleaner element (more frequently when operating the machine in dusty or dirty operating conditions). Figure 18 1. Press the top tab on the air cleaner cover (Figure and open the cover.
  • Page 14: Lubricating The Upper Handle

    Adjusting the Self-Propel Drive 9. Install the dipstick securely. 10. Recycle the used oil properly. If your machine does not self-propel properly, adjust the self-propel drive cable. Lubricating the Upper Handle 1. Loosen the nut on the cable mount (Figure 22).
  • Page 15: Replacing The Blade

    Note: You can place a ruler against the upper side of 5. Install the new blade (turn the blade bolt clockwise) the black cable mount and measure how far the upper and all mounting hardware (Figure 25). end of the cable jacket moves (Figure 24).
  • Page 16: Cleaning Under The Machine

    Cleaning under the Machine Storage Service Interval: After each use Store the machine in a cool, clean, dry place. WARNING Preparing the Machine for The machine may dislodge material from under the Storage machine. • Wear eye protection. WARNING • Stay in the operating position (behind the Gasoline vapors can explode.
  • Page 17: Removing The Machine From Storage

    Figure 27 1. Upper handle knob 2. Handle knobs 2. Loosen the handle knobs until you can move the handle freely (Figure 27). 3. Move the handle forward as shown in Figure Removing the Machine from Storage 1. Remove the spark plug and spin the engine rapidly by pulling the recoil-start handle to blow the excess oil from the cylinder.
  • Page 18 Notes:...
  • Page 19 The Way Toro Uses Information Toro may use your personal information to process warranty claims, to contact you in the event of a product recall and for any other purpose which we tell you about. Toro may share your information with Toro's affiliates, dealers or other business partners in connection with any of these activities. We will not sell your personal information to any other company.
  • Page 20 Toro's option, under warranty at no cost for parts and labor. Frame failure due to misuse or abuse and failure or repair required due to rust or corrosion are not covered.

Table of Contents