Toro 20835 Operator's Manual

48cm super bagger lawn mower
Hide thumbs Also See for 20835:

Advertisement

Quick Links

48cm Super Bagger Lawn Mower
Model No. 20835-Serial No. 315000001 and Up
Model No. 20836-Serial No. 315000001 and Up

Introduction

This rotary-blade, walk-behind lawn mower is intended
to be used by residential homeowners. It is designed
primarily for cutting grass on well-maintained lawns
on residential properties. It is not designed for cutting
brush or for agricultural uses.
Read this information carefully to learn how to operate and
maintain your product properly and to avoid injury and
product damage. You are responsible for operating the
product properly and safely.
You may contact Toro directly at www.Toro.com for product
and accessory information, help finding a dealer, or to register
your product.
Whenever you need service, genuine Toro parts, or additional
information, contact an Authorized Service Dealer or Toro
Customer Service and have the model and serial numbers of
your product ready.
Figure 1
model and serial numbers on the product.
1. Model and serial number plate
Write the product model and serial numbers in the space
below:
Model No.
Serial No.
This manual identifies potential hazards and has safety
messages identified by the safety alert symbol
© 2014-The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
identifies the location of the
Figure 1
(Figure
Register at www.Toro.com.
which signals a hazard that may cause serious injury or death
if you do not follow the recommended precautions.
1. Safety alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical information
and Note emphasizes general information worthy of special
attention.
This product complies with all relevant European directives.
For details, see the separate product specific Declaration of
Conformity (DOC) sheet.
Net Torque: The gross or net torque of this engine was
laboratory rated by the engine manufacturer in accordance
with the Society of Automotive Engineers (SAE) J1940.
As configured to meet safety, emission, and operating
requirements, the actual engine torque on this class of mower
will be significantly lower. Go to www.Toro.com to view
specifications on your mower model.
Do not tamper with the engine controls or alter the governor
speed; doing so may create an unsafe condition resulting in
personal injury.
Contents
Introduction .................................................................. 1
Safety ........................................................................... 2
General Lawn Mower Safety ..................................... 2
Sound Pressure ...................................................... 3
Sound Power .......................................................... 3
Hand-Arm Vibration ............................................... 4
Safety and Instructional Decals ................................. 4
Setup ............................................................................ 5
1 Unfolding the Handle............................................ 5
Guide................................................................. 5
3 Filling the Engine with Oil...................................... 6
4 Assembling the Grass Bag ...................................... 6
Product Overview .......................................................... 7
Specifications ......................................................... 7
2),
Operation ..................................................................... 8
Printed in the Czech Republic
Form No. 3392-965 Rev A
Operator's Manual
Figure 2
Original Instructions (EN)
All Rights Reserved *3392-965* A

Advertisement

Table of Contents
loading

Summary of Contents for Toro 20835

  • Page 1: Table Of Contents

    This manual uses 2 words to highlight information. product properly and safely. Important calls attention to special mechanical information You may contact Toro directly at www.Toro.com for product and Note emphasizes general information worthy of special and accessory information, help finding a dealer, or to register attention.
  • Page 2: Safety

    Toro designed and tested this lawn mower to offer reasonably safe service; however, failure to comply with the following • Before using, always visually inspect to see that guards and instructions may result in personal injury.
  • Page 3: Sound Pressure

    To ensure the best performance and safety, transportation when crossing surfaces other than grass purchase only genuine Toro replacement parts and and when transporting the machine to and from the area accessories. Do not use will fit parts and accessories;...
  • Page 4: Hand-Arm Vibration

    Hand-Arm Vibration CAUTION Long-term exposure to vibration while operating Measured vibration level for the left hand = 4.8 m/s the machine may cause some numbness in the Measured vibration level for the right hand = 5.5 m/s hands and wrists. Uncertainty Value (K) = 2.2 m/s Wear gloves that dampen the vibration whenever you operate the machine for an extended period of...
  • Page 5: Setup

    Setup 4. Rotate the handle rearward to the operating position, and lock the handle at your desired height. Refer to Adjusting the Handle Height (page Unfolding the Handle Installing the Recoil-Starter No Parts Required Rope in the Rope Guide Procedure No Parts Required WARNING Procedure...
  • Page 6: Filling The Engine With Oil

    steps through until the oil level on the dipstick is correct. • If the oil level is too high, drain the excess oil until the oil level on the dipstick is correct. To drain the Filling the Engine with Oil excess oil, refer to Changing the Engine Oil (page 14).
  • Page 7: Product Overview

    3. Hook the top and side channels of the bag onto the top and sides of the frame, respectively (Figure Specifications Model Weight Length Width Height 20835 38 kg 152 cm 53 cm 109 cm (84 lb) inches) inches) inches)
  • Page 8: Operation

    Operation Filling the Fuel Tank DANGER Gasoline is extremely flammable and explosive. A fire or explosion from gasoline can burn you and others. • To prevent a static charge from igniting the Figure 10 gasoline, place the container and/or machine directly on the ground before filling, not in a vehicle or on an object.
  • Page 9: Adjusting The Cutting Height

    Note: The approximate cutting height settings are A= 25 5. Remove the dipstick and read the oil level on the dipstick (Figure 11). mm (1 inch); B= 38 mm (1-1/2 inch); C=51 mm (2 inches); D=64 mm (2-1/2 inches); E=83 mm (3-1/4 inches); F=95 •...
  • Page 10: Starting The Engine

    Starting the Engine Using the Self-Propel Drive 1. Hold the blade-control bar (Figure 14) against the To operate the self-propel drive, simply walk with your hands handle. on the upper handle and your elbows at your sides, and the machine will automatically keep pace with you (Figure 16).
  • Page 11: Recycling The Clippings

    Check the grass bag frequently. If it is damaged, Use the rear discharge for cutting very tall grass. install a new Toro replacement bag. Note: If the grass bag is on the machine, remove it before rear-discharging the clippings; refer to...
  • Page 12: Operating Tips

    • For best performance, install a new blade before the cutting season begins. • Replace the blade when necessary with a Toro replacement blade. Cutting Grass • Cut only about a third of the grass blade at a time. Do not...
  • Page 13: Maintenance

    Maintenance Note: Determine the left and right sides of the machine from the normal operating position. Recommended Maintenance Schedule(s) Maintenance Service Maintenance Procedure Interval • Change the engine oil. After the first 5 hours • Check the engine-oil level. Before each use or daily •...
  • Page 14: Servicing The Air Cleaner

    Servicing the Air Cleaner Changing the Engine Oil Service Interval: Yearly Service Interval: After the first 5 hours 1. Press down on the latch tabs on top of the air-cleaner Yearly cover (Figure 21). 1. Move the machine to a level surface. 2.
  • Page 15: Servicing The Spark Plug

    5. Set the gap on the plug to 0.76 mm (0.030 inch) as shown in Figure Figure 24 1. Center electrode insulator 3. Air gap (not to scale) 2. Side electrode 6. Install the spark plug and the gasket seal. 7.
  • Page 16: Cleaning Under The Machine

    (Figure 27). Service Interval: After each use Cleaning under the Machine without a Washout Port (Model 20835 only) WARNING The machine may dislodge material from under the machine. • Wear eye protection. • Stay in the operating position (behind the handle) when the engine is running.
  • Page 17: Storage

    Storage 5. Check the engine-oil level; refer to Checking the Engine-Oil Level (page Store the machine in a cool, clean, dry place. 6. Fill the fuel tank with fresh gasoline; refer to Filling the Fuel Tank (page Preparing the Machine for 7.
  • Page 18 Notes:...
  • Page 19 The Way Toro Uses Information Toro may use your personal information to process warranty claims, to contact you in the event of a product recall and for any other purpose which we tell you about. Toro may share your information with Toro's affiliates, dealers or other business partners in connection with any of these activities. We will not sell your personal information to any other company.
  • Page 20 Toro's option, under warranty at no cost for parts and labor. Frame failure due to misuse or abuse and failure or repair required due to rust or corrosion are not covered.

This manual is also suitable for:

20836

Table of Contents