Toro 20835 Operator's Manual
Toro 20835 Operator's Manual

Toro 20835 Operator's Manual

48cm super bagger lawn mower and 48cm super recycler lawn mower
Hide thumbs Also See for 20835:

Advertisement

Quick Links

48cm Super Bagger Lawn Mower and 48cm Super
Recycler Lawn Mower
Model No. 20835-Serial No. 314000001 and Up
Model No. 20836-Serial No. 314000001 and Up

Introduction

This rotary-blade, walk-behind lawn mower is intended
to be used by residential homeowners. It is designed
primarily for cutting grass on well-maintained lawns
on residential properties. It is not designed for cutting
brush or for agricultural uses.
Read this information carefully to learn how to operate and
maintain your product properly and to avoid injury and
product damage. You are responsible for operating the
product properly and safely.
You may contact Toro directly at www.Toro.com for product
and accessory information, help finding a dealer, or to register
your product.
Whenever you need service, genuine Toro parts, or additional
information, contact an Authorized Service Dealer or Toro
Customer Service and have the model and serial numbers of
your product ready. Figure 1 identifies the location of the
model and serial numbers on the product.
1. Model and serial number plate
Write the product model and serial numbers in the space
below:
Model No.
Serial No.
© 2013-The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Figure 1
Register at www.Toro.com.
This manual identifies potential hazards and has safety
messages identified by the safety alert symbol (Figure 2),
which signals a hazard that may cause serious injury or death
if you do not follow the recommended precautions.
1. Safety alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical information
and Note emphasizes general information worthy of special
attention.
This product complies with all relevant European directives.
For details, see the separate product specific Declaration of
Conformity (DOC) sheet.
For models with stated engine horsepower, the gross
horsepower of the engine was laboratory rated by the engine
manufacturer in accordance with SAE J1940. As configured
to meet safety, emission, and operating requirements, the
actual engine horsepower on this class of lawn mower will
be significantly lower.
Do not tamper with the engine controls or alter the governor
speed; doing so may create an unsafe condition resulting in
personal injury.
Contents
Introduction .................................................................. 1
General Lawn Mower Safety ..................................... 2
Sound Pressure ...................................................... 3
Sound Power .......................................................... 3
Hand-Arm Vibration ............................................... 3
Safety and Instructional Decals ................................. 4
Setup ............................................................................ 5
1 Unfolding the Handle............................................ 5
Guide................................................................. 5
3 Filling the Engine with Oil...................................... 6
Product Overview .......................................................... 7
Specifications ......................................................... 7
Original Instructions (EN)
All Rights Reserved *3380-986* A
Printed in the Czech Republic
Form No. 3380-986 Rev A
Operator's Manual
Figure 2

Advertisement

Table of Contents
loading

Summary of Contents for Toro 20835

  • Page 1: Table Of Contents

    You are responsible for operating the product properly and safely. This manual uses 2 words to highlight information. You may contact Toro directly at www.Toro.com for product Important calls attention to special mechanical information and accessory information, help finding a dealer, or to register and Note emphasizes general information worthy of special your product.
  • Page 2: General Lawn Mower Safety

    • Replace all fuel tank and container caps securely. comply with these safety instructions. Preparation Toro designed and tested this lawn mower to offer reasonably safe service; however, failure to comply with the following • While mowing, always wear substantial footwear and long instructions may result in personal injury.
  • Page 3: Sound Pressure

    To ensure the best performance and safety, and when transporting the machine. purchase only genuine Toro replacement parts and accessories. Do not use will fit parts and accessories; • Do not operate the engine in a confined space where they may cause a safety hazard.
  • Page 4: Safety And Instructional Decals

    Safety and Instructional Decals Important: Safety and instruction decals are located near areas of potential danger. Replace damaged decals. Manufacturer's Mark 1. Indicates the blade is identified as a part from the original machine manufacturer. 114-7982 1. Warning—read the Operator's Manual. 2.
  • Page 5: Setup

    Setup 4. Rotate the handle rearward to the operating position, and lock the handle at your desired height. Refer to Adjusting the Handle Height (page 9). Unfolding the Handle Installing the Recoil-starter No Parts Required Rope in the Rope Guide Procedure No Parts Required WARNING...
  • Page 6: Filling The Engine With Oil

    steps through 5 until the oil level on the dipstick is correct. • If the oil level is too high, drain the excess oil until the oil level on the dipstick is correct. To drain the Filling the Engine with Oil excess oil, refer to Changing the Engine Oil (page 14).
  • Page 7: Product Overview

    Specifications fire or explosion from gasoline can burn you and Model Weight Length Width Height others. 20835 38 kg 152 cm 53 cm 109 cm • To prevent a static charge from igniting the (84 lb) (60 in) (21 in)
  • Page 8: Checking The Engine Oil Level

    3. Wipe off the dipstick end with a clean cloth. 4. Insert the dipstick into the oil-fill tube, but do not screw it in. 5. Remove the dipstick and read the oil level on the dipstick (Figure 9). • If the oil level is too low, add a small amount of oil slowly to the oil-fill tube, and then repeat steps 3 through 5 until the oil level on the dipstick is correct.
  • Page 9: Adjusting The Handle Height

    Adjusting the Handle Height You may raise or lower the upper handle to a position comfortable for you. Rotate the handle lock, move the handle to 1 of 3 positions, and lock the handle into position (Figure 11). Figure 10 1.
  • Page 10: Starting The Engine

    Starting the Engine 1. Hold the blade-control bar (Figure 12) against the handle. Figure 14 Stopping the Engine Service Interval: Before each use or daily—Ensure that the engine stops within 3 seconds after releasing the blade control bar. To stop the engine, release the blade-control bar (Figure 15). Important: When you release the blade-control bar, both the engine and blade should stop within 3 seconds.
  • Page 11: Recycling The Clippings

    Check the grass bag frequently. If it is damaged, Use the rear discharge for cutting very tall grass. install a new Toro replacement bag. Note: If the grass bag is on the machine, remove it before rear-discharging the clippings; refer to Removing the Grass WARNING Bag (page 11).
  • Page 12: Operating Tips

    • For best performance, install a new blade before the cutting season begins. • Replace the blade when necessary with a Toro replacement blade. Cutting Grass • Cut only about a third of the grass blade at a time. Do not...
  • Page 13: Maintenance

    Maintenance Note: Determine the left and right sides of the machine from the normal operating position. Recommended Maintenance Schedule(s) Maintenance Service Maintenance Procedure Interval • Change the engine oil. After the first 5 hours • Check the engine oil level. Before each use or daily •...
  • Page 14: Servicing The Air Cleaner

    Servicing the Air Cleaner Changing the Engine Oil Service Interval: Yearly Service Interval: After the first 5 hours 1. Press down on the latch tabs on top of the air-cleaner Yearly cover (Figure 19). 1. Move the machine to a level surface. 2.
  • Page 15: Servicing The Spark Plug

    5. Set the gap on the plug to 0.76 mm (0.030 in) as shown in Figure 22. Figure 22 1. Center electrode insulator 3. Air gap (not to scale) 2. Side electrode 6. Install the spark plug and the gasket seal. 7.
  • Page 16: Cleaning Under The Machine Housing

    Service Interval: After each use (Figure 25). Cleaning under the Housing without a Washout Port (Model 20835 only) WARNING The machine may dislodge material from under the machine housing. • Wear eye protection.
  • Page 17: Storage

    Storage 5. Check the engine oil level; refer to Checking the Engine Oil Level (page 8). Store the machine in a cool, clean, dry place. 6. Fill the fuel tank with fresh gasoline; refer to Filling the Fuel Tank (page 7). Preparing the Machine for 7.
  • Page 18 Notes:...
  • Page 19 The Way Toro Uses Information Toro may use your personal information to process warranty claims, to contact you in the event of a product recall and for any other purpose which we tell you about. Toro may share your information with Toro's affiliates, dealers or other business partners in connection with any of these activities. We will not sell your personal information to any other company.
  • Page 20 Authorized Toro Service Dealer. tractor structure that other components such as the engine are secured to, cracks or breaks in normal use, it will be repaired or replaced, at Toro's option, under warranty at no cost for parts General Conditions and labor.

This manual is also suitable for:

20836

Table of Contents