Servicing The Hydraulic System - Toro 30187 Operator's Manual

1
Figure 28
1. Hose clamp
2. Fuel line

Servicing the Hydraulic System

Checking the Hydraulic Fluid
Check the hydraulic fluid level before engine is first started
and after every 8 operating hours.
Fluid Type: Mobilube 424 (ISO 68) or equivalent anti–wear
hydraulic fluid.
Important Use only hydraulic oils specified. Other
fluids could cause system damage.
Tank Capacity: 1-3/4 quarts (1.6 liter)
1. Position machine on a level surface and stop the engine.
2. Clean area around filler neck and cap\dipstick of
hydraulic tank (Fig. 29).
3. Remove cap\dipstick from filler neck and wipe with a
clean rag. Insert cap\dipstick and seat cap all the way
into filler neck; then remove and check fluid level.
Fluid level should be in between marks on dipstick.
4. If level is low, add fluid to raise level to full mark.
5. Install cap\dipstick onto filler neck.
3
2
m–2596
3. Filter
26
2
Figure 29
1. Hydraulic tank cap
Replacing the Hydraulic Filter
Change the hydraulic filter:
• After the first 8 operating hours.
• After every 200 operating hours.
1. Position machine on a level surface, stop the engine,
and remove key from ignition switch.
Important
Do not substitute automotive oil filter or
severe hydraulic system damage may result.
2. Place drain pan under filter, remove the old filter and
wipe the filter adapter gasket surface (Fig. 30).
Note: Make sure fluid is completely drained before
installing new filter.
Figure 30
1. Hydraulic filter
3. Apply a thin coat of new oil to the rubber gasket on the
replacement filter (Fig. 31).
1
m–2613
2. Fuel tank cap\dipstick
1
m–2623