Installing The Battery - Toro 30187 Operator's Manual

6. Connect rod to upper control bars with previously
removed hairpin cotter, tighten wing nut and
turnbuckle.
1
5
4
Figure 5
1. Control rod–right
2. Control bracket
3. Hairpin cotter
Adjusting the Tracking
1. After completing assembly check machine tracking.
Operate machine by holding upper control bar against
reference bar with wheel drive engaged.
2. If machine does not track straight, moves more right or
left, adjustment is required.
3. Loosen wing nut on right control rod and rotate
turnbuckle in or out to change tracking. Secure
turnbuckle in position with wing nut (Fig. 5).
4. Check for proper tracking.
Note: Control rods must be adjusted if handle height
position is changed.
3
2
m–3103
4. Wing nut
5. Turnbuckle

Installing the Battery

Warning
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. Wash hands after
handling.
1. Mount battery holders to back side of left rear corner of
cutting unit carrier frame with 2 bolts (3/8 x 1-3/4 inch)
and locknuts (3/8 inch) (Fig. 6).
2. Peel off backing from battery pads and affix pads to
battery holder, positioning as shown in Fig. 6.
3. Fill battery with electrolyte and charge, refer to
Servicing the Battery, page 30.
1
1. Battery holder
4. Position battery onto holder with terminal posts away
from the engine (Fig. 7).
5. Slide the red terminal boot onto the red battery cable
and the black terminal boot onto the the black battery
cable.
6. Install the positive (red) battery cable to positive (+)
battery terminal and the negative battery cable to the
negative (–) battery terminal. Secure cables with
2 carriage bolts (1/4 x 3/4 inch) and locknuts (1/4 inch).
13
m–2635
Figure 6
2. Battery pads
2