Stopping The Machine; Adjusting The Height Of Cut - Toro 74906 Operator's Manual

Driving Forward
Note: The engine shuts off if you move the traction-control
levers with the parking brake engaged.
To stop, pull the motion-control levers to the N
position.
1. Release the parking brake; refer to
Parking Brake (page
2. Move the levers to the center, unlocked position.
3. To go forward, slowly push the motion-control levers
forward (Figure 22).
Figure 22
EUTRAL
Releasing the
18).
G008952
Driving Backward
1. Move the levers to the center, unlocked position.
2. To go backward, slowly pull the motion-control levers
rearward (Figure

Stopping the Machine

To stop the machine, move the motion-control levers to
neutral and then to the N
the blade-control switch (PTO), and turn the ignition key to
the O position.
FF
Set the parking brake when you leave the machine; refer to
Setting the Parking Brake (page
the ignition switch.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.

Adjusting the Height of Cut

Using the Transport Lock
The transport lock has 2 positions, and is used with the
deck-lift pedal. There is a L
22
23).
G008953
Figure 23
- position, disengage
EUTRAL LOCK
18). Remove the key from
position and an U
OCK NLOCK