Adjusting The Tracking Of The Traction Control, Full Forward Position - Toro 22323 Operator's Manual

1. Traction rod
4. Start the traction unit and set the throttle to about
1/3 open position.
When the traction unit is running, you could be
caught and injured in moving parts or burned
on hot surfaces.
Stay away from pinch points, moving parts,
and hot surfaces when adjusting the running
traction unit.
5. If the left track moves, lengthen or shorten the right
traction rod until the track stops moving.
6. If the right track moves, lengthen or shorten the left
traction rod until the track stops moving.
7. Tighten the jam nuts.
8. Close the rear access cover.
9. Stop the engine and lower the traction unit to the
ground.
10. Drive the traction unit in full reverse, checking to
see if the unit tracks straight. If it does not, note
the direction the traction unit veers. Repeat the
adjustment previously described so that it tracks
straight in reverse.
Adjusting the Tracking of the
Traction Control, Full Forward
Position
If the traction unit does not drive straight when you hold
the traction control against the reference bar, complete
the following procedure:
Figure 53
2. Jam nut
1. Drive the traction unit with the traction control
against the reference bar, noting which direction the
traction unit veers.
2. Release the traction control.
3. If the traction unit veers to the left, loosen the right
jam nut and adjust the tracking set screw on the front
of the traction control (Figure 54).
4. If the traction unit veers to the right, loosen the
left jam nut and adjust the tracking set screw on the
front of the traction control (Figure 54).
1. Set screw
2. Jam nut
5. Repeat steps 1 through 4 until the traction unit drives
straight in the full forward position.
Important: Ensure the tracking set screws
touch the stops in the full forward position to
avoid over stroking the hydraulic pumps.
42
Figure 54
3. Stop